Jump to content
SAU Community

Recommended Posts

Hey Guys,

Not sure if this is in the right area but I have a random issue with my car and no one seems to be able to isolate it? Its been to two mechanics about half a dozen times in total, we've changed a few bits and pieces but still happening! It went to one mechanic 4 times before he 'witnessed' the issue...to give an idea how random it is...

It's an R32 GTS-t manual, only mod is a muffler (came with the car). The issue I am having is really random...most of the time it runs fine...but sometimes it would stall, the idle would rise & drop all on its own or the idle would rise to about 2500rpm and stay there...it's really odd...it doesn't do it all the time or even consistently. The ONLY clue is it tends to run worse the less fuel it has - but that could just be a coincidence. I've had the car serviced with platinums to be sure...the AFM checked and recently my mechanic replaced coil pack 5 as it was 'burnt' out? - but its STILL doing it...? Any ideas?

Edited by 4doorHCR32
Link to comment
https://www.sau.com.au/forums/topic/118241-help-random-r32-gts-t-problem/
Share on other sites

Hey Guys,

Not sure if this is in the right area but I have a random issue with my car and no one seems to be able to isolate it? Its been to two mechanics about half a dozen times in total, we've changed a few bits and pieces but still happening! It went to one mechanic 4 times before he 'witnessed' the issue...to give an idea how random it is...

It's an R32 GTS-t manual, only mod is a muffler (came with the car). The issue I am having is really random...most of the time it runs fine...but sometimes it would stall, the idle would rise & drop all on its own or the idle would rise to about 2500rpm and stay there...it's really odd...it doesn't do it all the time or even consistently. The ONLY clue is it tends to run worse the less fuel it has - but that could just be a coincidence. I've had the car serviced with platinums to be sure...the AFM checked and recently my mechanic replaced coil pack 5 as it was 'burnt' out? - but its STILL doing it...? Any ideas?

vacuum leak causes this, or a hold on the rubber front pipe on the turbo AFTER the afm could be leaking.. sounds exactly like the problem i had. ended up being a hole burnt thru the feed pipe to the turbo... in otherwords, the engine is getting more air than the afm is reading, running super lean, and on idle can stall, and vary revs constantly

****UPDATE****

Now we have a new element to the problem! - the car won't rev past 2500rpm...and when you press it past that point, it sounds/feels like its hitting the limiter...?? - this is particularly annoying on the freeway...as 2500 in 5th is about 75-80km...still sound like a post-AFM leak?

I'm pulling the intake out this weekend and having a good look at it, any further ideas won't hurt...

:D

Unplugg the oxygen sensor and see if it fixes the problem (leave the oxygen sensor in the dump pipe), if it fixes the problem then you have a stuffed oxygen sensor, i had a simillar prolem with my car a couple of weeks ago.Let us know if it fixes it

Edited by nizmo_freek
  • 4 weeks later...

Hey all...I checked the inlet side and everything is fine...it started to play up again so I disconnedcted the o2 sensor and it drove perfectly for about 150km but now its doing it again...??? Could this still be the o2 sensor? I might try with the multi meter...any ideas would be great...BLKGTS4R32 pm'd be as he's having the same issues!!! :O

I basically pulled the whole inlet out and checked for leaks..(as suggested above)...everything is fine...I didn't check the AFM as such...that said, I have a Q45 on the way for it...I am suspecting its the o2 sensor...but would rather be sure as I've spent 4-500 already 'chasing' this thing... :O

Also, R32 GTS-t o2 sensor can only be purchased thru Nissan I am told? $165.00 + GST...

Thanks guys - much appreciated!!!

Nismo I AM in Melbourne, I have an AFM on the way (doing a 'round of mods atm - FMIC, 2535 etc) and I am planning on getting the ECU remapped - would this help? ie if there is an issue with the ECU, will a re-map correct this? Also - and apologies for being off topic - can you suggest anyone skilled in the art of re-mapping? I want to retain the factory ecu...

Edited by 4doorHCR32

RE-mapped ECU woudn't help if the ECU is dead. and "can you suggest anyone skilled in the art of re-mapping?" Nope the stuff i've heard abuot ppl in melb remapped stock ecu not good.

Thanks guys - much appreciated!!!

Nismo I AM in Melbourne, I have an AFM on the way (doing a 'round of mods atm - FMIC, 2535 etc) and I am planning on getting the ECU remapped - would this help? ie if there is an issue with the ECU, will a re-map correct this? Also - and apologies for being off topic - can you suggest anyone skilled in the art of re-mapping? I want to retain the factory ecu...

I think that you may have the problem that i had with my r32

Does ur cars rpm "hunt" ie. the revs go up and down when u stop or start it up ?

Does it idle at like 2000 to 2500 RPM once it stops hunting.(if it stops hunting at all)

I had this issue with my car and i tried everything to fix it but in the end it was the Cold Start Solenoid. Located just under the cross over pipe, between ur intake plume and the cam cover. It will look like a thin square "floppy disk" shaped object with two pipes going into each side of it, my guess it that it is this.

Rb motors are very prone for stuffing up this part. get a new one Not a second hand one cos you will probably have the same problem.

Hope this helps.

Thanks R32FOURDOOR (and awesome choice in vehicle might I add... :laugh: ) - I thionk I have found the solution!

BLKGTS4R32 came good with this link;

http://www.skylinesaustralia.com/forums/in...opic=113284&hl=

I've given it a shot and will be putting it all back together tomorrow for a test...fingers crossed!

:D

I had this problem that things i changed were:

AFM

TPS sensor

Adjusted idle screw

Cleaned out trottle body+butterfly

Cleaned AAC valve

Reset ecu

took air filter off(HKS TYPE)

Changed that solenoid on the aac valve(gold round thing on back of intake plume)

Changed oil

Changed coolant

cleaned everthing that i could

None of this changed my problem at all

In the end was Cold Start Sensor, im pretty sure that this is ur problem

Heres some pic of where it is.

Ps ill try and also get part no of it

post-24677-1150885180.jpg

post-24677-1150885214.jpg

  • 5 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If they can dyno them, get them dyno'd, make sure they're not leaking, and if they look okay on the dyno and are performing relatively well, put them in the car.   If they're leaking oil etc, and you feel so inclined, open them up yourself and see what you can do to fix it. The main thing you're trying to do is replace the parts that perish, like seals. You're not attempting to change the valving. You might even be able to find somewhere that has the Tein parts/rebuild kit if you dig hard.
    • Can you also make sure the invoices on the box (And none exist in the boxes) are below our import duty limits... I jest, there's nothing I need to actually purchase and order in. (Unless you can find me a rear diff carrier, brand new, for stupidly cheap, that is for a Toyota Landcruiser, HZJ105R GXL, 2000 year model...)  
    • Murphy strikes again! Nothing at all would have gone wrong if you had the tool kit in the car! You'd have just found the clamp loose the next time you went to touch it...
    • I have been being VERY quiet about what you're alluding to, as it is something that ticks me off... The number of cars from factory that run coil overs is HUGE! Most of them these days do... The other part that annoys me, is people saying "Well all the incabin adjustable suspension is illegal by blah blah blah"... If that's the case, then why can I buy a car brand new that can do it if, FULL STOP in cabin adjustable suspension is illegal...   Also, I could just chuck some aftermarket shocks in my car, throw the stock springs on, after my blue slip, dump my super low springs back in. Same shock and spring style setup... Hell, they could also be the same colour springs etc.     I'm voting, BlueSlipper didn't want to touch the above car for some reason. Whether it be some sort of bias against the car, the owner, them maybe having previously done dodgy shit and now they're being super careful in case they get slapped in the face by the Gumbyment again... Find a new blueslip place.   And can confirm as you had said, yes there are holy bibles of vehicle heights, and all sorts of other suspension stuff. Heck your run of the mill mechanic, and tyre shop has access to all of that stuff. It's how they do wheel alignments...
    • Funny story Heading to Sydney this morning on the HWY there was some slow traffic, so I gave it the beans and midway through my overtaking "power run" I lost all power It seems that I missed a hose clamp,  and the MAF and filter went WiFi To make this more problematic, the little tool kit that lives in the boot, is sitting in the sun room at Goulburn......LOL Luckily for me I found a bit of steel on the side of the road that could be used like a rusty and bent flat head screw driver to tighten it up enough that it got me into Sydney, it is now all tight like a tiger with the aid of a 8mm socket Note to self: Use my brain and double check stuff, and always keep that little tool kit in the car for when I have a brain fart
×
×
  • Create New...