Jump to content
SAU Community

Recommended Posts

Hey Guys,

Not sure if this is in the right area but I have a random issue with my car and no one seems to be able to isolate it? Its been to two mechanics about half a dozen times in total, we've changed a few bits and pieces but still happening! It went to one mechanic 4 times before he 'witnessed' the issue...to give an idea how random it is...

It's an R32 GTS-t manual, only mod is a muffler (came with the car). The issue I am having is really random...most of the time it runs fine...but sometimes it would stall, the idle would rise & drop all on its own or the idle would rise to about 2500rpm and stay there...it's really odd...it doesn't do it all the time or even consistently. The ONLY clue is it tends to run worse the less fuel it has - but that could just be a coincidence. I've had the car serviced with platinums to be sure...the AFM checked and recently my mechanic replaced coil pack 5 as it was 'burnt' out? - but its STILL doing it...? Any ideas?

Edited by 4doorHCR32
Link to comment
https://www.sau.com.au/forums/topic/118241-help-random-r32-gts-t-problem/
Share on other sites

Hey Guys,

Not sure if this is in the right area but I have a random issue with my car and no one seems to be able to isolate it? Its been to two mechanics about half a dozen times in total, we've changed a few bits and pieces but still happening! It went to one mechanic 4 times before he 'witnessed' the issue...to give an idea how random it is...

It's an R32 GTS-t manual, only mod is a muffler (came with the car). The issue I am having is really random...most of the time it runs fine...but sometimes it would stall, the idle would rise & drop all on its own or the idle would rise to about 2500rpm and stay there...it's really odd...it doesn't do it all the time or even consistently. The ONLY clue is it tends to run worse the less fuel it has - but that could just be a coincidence. I've had the car serviced with platinums to be sure...the AFM checked and recently my mechanic replaced coil pack 5 as it was 'burnt' out? - but its STILL doing it...? Any ideas?

vacuum leak causes this, or a hold on the rubber front pipe on the turbo AFTER the afm could be leaking.. sounds exactly like the problem i had. ended up being a hole burnt thru the feed pipe to the turbo... in otherwords, the engine is getting more air than the afm is reading, running super lean, and on idle can stall, and vary revs constantly

****UPDATE****

Now we have a new element to the problem! - the car won't rev past 2500rpm...and when you press it past that point, it sounds/feels like its hitting the limiter...?? - this is particularly annoying on the freeway...as 2500 in 5th is about 75-80km...still sound like a post-AFM leak?

I'm pulling the intake out this weekend and having a good look at it, any further ideas won't hurt...

:D

Unplugg the oxygen sensor and see if it fixes the problem (leave the oxygen sensor in the dump pipe), if it fixes the problem then you have a stuffed oxygen sensor, i had a simillar prolem with my car a couple of weeks ago.Let us know if it fixes it

Edited by nizmo_freek
  • 4 weeks later...

Hey all...I checked the inlet side and everything is fine...it started to play up again so I disconnedcted the o2 sensor and it drove perfectly for about 150km but now its doing it again...??? Could this still be the o2 sensor? I might try with the multi meter...any ideas would be great...BLKGTS4R32 pm'd be as he's having the same issues!!! :O

I basically pulled the whole inlet out and checked for leaks..(as suggested above)...everything is fine...I didn't check the AFM as such...that said, I have a Q45 on the way for it...I am suspecting its the o2 sensor...but would rather be sure as I've spent 4-500 already 'chasing' this thing... :O

Also, R32 GTS-t o2 sensor can only be purchased thru Nissan I am told? $165.00 + GST...

Thanks guys - much appreciated!!!

Nismo I AM in Melbourne, I have an AFM on the way (doing a 'round of mods atm - FMIC, 2535 etc) and I am planning on getting the ECU remapped - would this help? ie if there is an issue with the ECU, will a re-map correct this? Also - and apologies for being off topic - can you suggest anyone skilled in the art of re-mapping? I want to retain the factory ecu...

Edited by 4doorHCR32

RE-mapped ECU woudn't help if the ECU is dead. and "can you suggest anyone skilled in the art of re-mapping?" Nope the stuff i've heard abuot ppl in melb remapped stock ecu not good.

Thanks guys - much appreciated!!!

Nismo I AM in Melbourne, I have an AFM on the way (doing a 'round of mods atm - FMIC, 2535 etc) and I am planning on getting the ECU remapped - would this help? ie if there is an issue with the ECU, will a re-map correct this? Also - and apologies for being off topic - can you suggest anyone skilled in the art of re-mapping? I want to retain the factory ecu...

I think that you may have the problem that i had with my r32

Does ur cars rpm "hunt" ie. the revs go up and down when u stop or start it up ?

Does it idle at like 2000 to 2500 RPM once it stops hunting.(if it stops hunting at all)

I had this issue with my car and i tried everything to fix it but in the end it was the Cold Start Solenoid. Located just under the cross over pipe, between ur intake plume and the cam cover. It will look like a thin square "floppy disk" shaped object with two pipes going into each side of it, my guess it that it is this.

Rb motors are very prone for stuffing up this part. get a new one Not a second hand one cos you will probably have the same problem.

Hope this helps.

Thanks R32FOURDOOR (and awesome choice in vehicle might I add... :laugh: ) - I thionk I have found the solution!

BLKGTS4R32 came good with this link;

http://www.skylinesaustralia.com/forums/in...opic=113284&hl=

I've given it a shot and will be putting it all back together tomorrow for a test...fingers crossed!

:D

I had this problem that things i changed were:

AFM

TPS sensor

Adjusted idle screw

Cleaned out trottle body+butterfly

Cleaned AAC valve

Reset ecu

took air filter off(HKS TYPE)

Changed that solenoid on the aac valve(gold round thing on back of intake plume)

Changed oil

Changed coolant

cleaned everthing that i could

None of this changed my problem at all

In the end was Cold Start Sensor, im pretty sure that this is ur problem

Heres some pic of where it is.

Ps ill try and also get part no of it

post-24677-1150885180.jpg

post-24677-1150885214.jpg

  • 5 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
×
×
  • Create New...