Jump to content
SAU Community

Recommended Posts

hmm they are taking for ever to load up... its clearly yours daz as the plates are 85urk

and shane i think its your black r33 where thw plates 413 iyn?

ohh! i thought u meant of my not my car lol yeah u would have some of my car send it to me in pm if u can il have a look 2moro i gota go. cya guys.

is the power pole ok that u hit isaac? :(

bryn, where are these other pics u speak of? man i miss that car :(

morning all :woot:

there was no power pole - a servo driveway in gladstone, and a tyre/embankment at mt cotton lol oh and the old lady that i did a hit an run for :P

she wasn't too bad - ol mate osteoporosis had kicked in so was like running into a big bird like an ibis - bones are brittle and hollow :P

so lesson learnt if you're going to hit a pedestrian make sure its a little old lady.

hey karen

which panel shop did your car go to and are they any good, i ask cos a friend of mine needs to get his white 33 repaired :P

I went to Kustom FX in Underwood (they are located at 13 Kenway Drive). They came recommended to me by Mushroom, who has had some work done there before. I was concerned about paint matching (mine being red and all), but your mate shouldn't have to worry about that too much with his being white :woot:

I was quite happy with the results...they also had to get plastic welding done as my grille was cracked - you can't even tell :(

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...