Jump to content
SAU Community

Recommended Posts

CRW_2174_800web.jpg

Well, I decided to go for an early morning dawn run down the Putty Road and take a few shots. This was extremely early in the morning though, hence the non-invite to others.

CRW_2176_800web.jpg

Traffic was non existant except for a few semi's which were going unbelievably fast for their size...but they were still holding me up.

CRW_2183_800web.jpg

Link to comment
https://www.sau.com.au/forums/topic/119824-putty-road/
Share on other sites

  • 3 weeks later...
how long does the drive usually take to complete the whole way? how many km is it and are the roads really smooth?

altogether from windsor if you go all the way to singelton its approx 170km, if you go from windsor to the end of the good bits its about 150km.

round trip from the city all up about 350km, at night it takes around 4-5 hours including stopping for petrol stuffing around etc. also keep in mind there is no petrol station open late at night at singleton so u have to fill up at windsor at the latest or you risk running out on the way home :O

the roads for the first 2/3 are good with some average sections, the end 1/3 has a lot of new surfaces so is very good. fair few wombats and kangaroos around too.

there is a freaky looking monastery half way with blue lit up crosses..

Link to comment
https://www.sau.com.au/forums/topic/119824-putty-road/#findComment-2265879
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
×
×
  • Create New...