Jump to content
SAU Community

Recommended Posts

HEY!

I've seen all the proven performance that the SAFC gives to turbo cars, but would it be able to give performance like this to N/A cars too?

I've got a Rb30e (R31 engine) with minor mods and there's shitloads of hype about the SAFC but no one has used it on a N/A application???

Is there a reason for this? Any help would be greatly appreciated!

Thanks

Tim

Link to comment
https://www.sau.com.au/forums/topic/12002-apexi-safc-na-engine/
Share on other sites

ATM i've got extractors, exhaust and a pod filter. I'll advance the timing a fraction when the price of premium isn't so ridiculously high!!!

and yes I run standard ECU. Probably making 95rwkw or so I'd guess. Maybe 90ish. Not positive though.

Also, is the SAFC better than the AFC or do u just pay for cos of the flashy blue screen?

improvements should be across the whole range but whether you feel it or not is another thing, but you should get better response after the tune.

SAFC has flashy blue screen can show you information like throttle position, speed etc...I believe they also do peak recalls too?

If you can, go the SAFC....maybe even SAFC-II as that has a bit more features over the SAFC.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • -10 is plenty for running to an oil cooler. When you look at oil feeds, like power steering feeds, they're much smaller, and then just a larger hose size to move volume in less pressure. No need for -12. Even on the race cars, like Duncans, and endurance cars, most of them are all running -10 and everything works perfectly fine, temps are under control, and there's no restrictions.
    • Update: O2 sensor in my downpipe turned out to be faulty when I plugged in to the Haltech software. Was getting a "open circuit" warning. Tons of carbon buildup on it, probably from when I was running rich for a while before getting it corrected. Replaced with new unit and test drove again. The shuffle still happens, albeit far less now. I am not able to replicate it as reliably and it no longer happens at the same RPM levels as before. The only time I was able to hear it was in 5th going uphill and another time in 5th where there was no noticeable incline but applying more throttle first sped it up and then cleared it. Then once in 4th when I slightly lifted the throttle going over a bump but cleared right after. My understanding is that with the O2 sensor out, the ECU relies entirely on the MAP tune and isn't able to make its small adjustments based on the sensors reading. All in all, a big improvement, though not the silver bullet. Will try validating the actuators are set up correctly, and potentially setting up shop time to tune the boost controller on closed loop rather than the open loop it is set to now. Think if it's set up on closed loop to take the O2 reading, that should deal with these last bits. Will try to update again as I go. 
    • More so GReddy oil relocation kits, sandwich plates, etc. all use 10AN fittings. And same, I've only used 10AN and my car sees track work (circuit, doing laps, not 10 sec squirt business).
    • street use or race track, what hose size and why? what factors change with the hose size options ?   see most comon is an10. when you see most oem external coolers are closer to an12? does high volume oil pump like nitto need an12 or 10 be just fine
×
×
  • Create New...