Jump to content
SAU Community

Sau Movie Night @ Drive In - Fast And Furious 3 - Fri 16th June 8:30pm


Recommended Posts

Hi all. Fast and Furious 3 is playing on FRIDAY 16th at 830pm at the Mainline Drive In.

Expect a busy nite so suggest get there at least 20 min b4.

If your up 4 a bite to eat b4 we head out, meet at KFC on Main North rd @ Prospect at 7pm for some special herbs n spices n then head up there at 8pm.

Dont know where were gona park, but would b good 2 all get in the same spot. Best if we meet all at KFC at 8pm then and all head up 2gether. So dont be late!

So far have

Myself

Madaz + 3

Nozilla

Shorty_01 + 1

Electro +2

R32chick

Maxx

Whiplash

mxtcy

Nightcrawler

Oosh

heslo

Have said yes to me..will update as ppl respond.

Cheers.

PS: will bring some jumper leads with me incase any1 gets flat batteries lol...

Edited by vange

At this stage Vange, looks like I'm on for it, depending on work commitments the next day.

By the way, you up for a little cruise tomorrow night? I know you are working late tonight but if you are free tomorrow I'm keen

ok looks like ill be getting there early vange with Lee 'R34' 4door and probably R32chick and the others i mention to u

any1 else that wishes is more than welcome to come @ the 6'oclock to watch Cars the movie too

register your interest for that and we can organise a meeting point near TTP

hey steve, so ur not meeting at kfc b4 hand? if so, ill meet every1 by 8pm at kfc, then we'll all drive up 2gether....ill prob b there at 7, cos i live on that street :P

save a good spot for us :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
×
×
  • Create New...