Jump to content
SAU Community

Recommended Posts

hi Lee

Just spoke with the manufacturer and he is finishing off all the pipes for this GB in the next couple of days. They will get sent out by the end of the week, so you should all recieve them mid next week. I will keep you all informed. Thank you for being all so patient!

Jackie,

Until all the pipes are sent out in this GB, the second GB wont start. So its likely that #2 will begin next week.

cheers

  • Replies 108
  • Created
  • Last Reply

Top Posters In This Topic

hi Lee

Just spoke with the manufacturer and he is finishing off all the pipes for this GB in the next couple of days. They will get sent out by the end of the week, so you should all recieve them mid next week. I will keep you all informed. Thank you for being all so patient!

Jackie,

Until all the pipes are sent out in this GB, the second GB wont start. So its likely that #2 will begin next week.

cheers

Thanks for letting me know.

I would like to please grab one next week in the #2 group buy please, if u havent already noticed :cheers:

hi Lee

Just spoke with the manufacturer and he is finishing off all the pipes for this GB in the next couple of days. They will get sent out by the end of the week, so you should all recieve them mid next week. I will keep you all informed. Thank you for being all so patient!

Jackie,

Until all the pipes are sent out in this GB, the second GB wont start. So its likely that #2 will begin next week.

cheers

Cheers mate!! :blink:

hi guys,

just an update on the pipes. 3 are being sent tomorrow:

STAGE-A

siddr20

skyline17

Everyone else's pipes are getting sent on Thursday, and that will be all the remaining people in the GB. Again, i apologise for how long its taken to get them sent out!

I have said this before, and I will say it again - fantastic product. Worth getting them, as the car just feels soo much better to drive. More responsive now - im almost tempted to take out my TRUST PE2 catback and seeing how it is with the standard exhaust installed.....

i will start another one on friday. but it will be a limit of people this time, otherwise it takes too long for all to recieve their pipes.

once again

please put me down. im extremely keen to do this. :laugh:

i will start another one on friday. but it will be a limit of people this time, otherwise it takes too long for all to recieve their pipes.

im 1st!!!!

hi guys

All pipes have now been sent out. Some should recieve them tomorrow, and all the rest will recieve them by early to mid next week depending on where you are located. Thank you to all who participated in the GB and for those that are keen on a second one, i will put up a thread today in the GB section. They will start to get made from today, this way most will be ready to send by the time the payment is due.

cheers

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...