Jump to content
SAU Community

Recommended Posts

Hi guys do you know of any one in Melbourne that remaps the stock rb25det ecu because the R&R in kicking in and using a lot of fuel and I don’t have the $$$$$ for a power fc

As far as I know the Rb25DET ECU cannot be remapped. Although you can call DR DRIFT on 0425818755. He does the remapping all over Australia.

Buy the way my car is a r32 gtst with a rb25det s1 motor in it.

To get rid of the R&R you could cut the sensor out of the afm and put it in a 90mm pipe instead of a 80mm pipe.

It could work just a thought, because the ecu thinks the boost is set a 10psi instead of 12. at 10psi the a/f is still rich so it might be for 12.

get a SAFC, either series 1 (~$50 used) or series 2 (~$200 used or $350 for new)

install it, make sure every bolt-on mod you're doing is on the car - and dyno tune.

more power and save $ in the long run.

hey,

i was going down this path with Dr Drift, he put the 32 ecu into my car and got it working on one of his stockish maps. never got around to tuning though, the contact just sort of broke off as he is a very busy man and i ended up getting a power fc instead. the 33 ecu uses a different chip which has the actual program embedded in the chip itself, which can't be wrewritten too and thus a new one must be installed which is expensive (this is the reason he gave to me). anyway as they say get in contact with Sam, he's a very smart bloke.

cheers,

mark.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So I'm going to have to keep ignoring the 4.7 update, or whatever version it is? Poop. I was hoping you'd put me out of my misery.
    • We have a huge update coming in the next few months, version 5 of Invision will be released. I'm holding off any changes until after this change as I'm not sure what features will be removed or introduced.
    • Yeah, plenty of air flow, there is a dedicated path that feeds the air in to the OEM intake tube behind the bumper As for a "tangible effect", maybe, but getting the pod/intake air out of the hot engine bay is worth it psychologically to me, even if it gives no performance difference, so the tangible effect in my Lizard brain saysss yessss  In the end, to me a tangible effect isn't always about performance, sometimes it a sound or a look, or even a...... feeling  Ooga-Chaka Ooga-Ooga Ooga-Chaka Ooga-Ooga Ooga-Chaka Ooga-Ooga Ooga-Chaka Ooga-Ooga
    • yeah first and reverse is where you will find clutch release issues (whether hydraulic or mechanical) because the difference in revs required is the highest there; particularly changing down from 2nd to 1st when still moving. To be clearer though, it is possible that the clutch release bearing is the wrong height. This is less likely than a hydraulic issue but it is not unheard of when you are mixing and matching
    • Quite right, if you make it to that pension you deserve every cent
×
×
  • Create New...