Jump to content
SAU Community

Recommended Posts

Looking for instuctions for the hks evc 3 and wondering if anybody knows where to download them in english. There has to be a place to get them, pretty much just want to know what the little switch on the back is saying sw or po? also what u attach the boost scrambeller too???

any help would be appreciated.

:(

Link to comment
https://www.sau.com.au/forums/topic/127590-hks-evc-3-instuctions/
Share on other sites

its on my site, check out my signature. sw and po are internal gate and external gate selector. scrambler switch is for temp higher boost mode, ie: run 10psi always and scramble to 12psi for 30 seconds when pressed

  • 5 months later...

with these pictures, do u have to do anything to the stock solenoid/lines like block the stock pipes off/take off connector to stock solenoid?.

or is that all u have to do to run the boost controller? im assuming these vaccums will replace the stock ones?.

thanks

guyss anyone know?. want to put this in tonight!!

jus need to know what happens to the vaccums from the stock solenoid (which im prettys ure will be replaced by new hks soleniod)

but more importantly do i have to do anything on the turbo side? as i was inspecting my mates r33 gtr and i saw nothing modified on the turbo/actuator side.

guyss anyone know?. want to put this in tonight!!

jus need to know what happens to the vaccums from the stock solenoid (which im prettys ure will be replaced by new hks soleniod)

but more importantly do i have to do anything on the turbo side? as i was inspecting my mates r33 gtr and i saw nothing modified on the turbo/actuator side.

Here is the evc2 ( in australia, people say it evc3) installation. http://mkiv.supras.org.nz/articles/hksevc.htm

hope can help u

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • So sadly the fuel pump etc was not it. The pump and filter is new and it is still cutting around 4000 rpm. A read something about ABS/TCS (engine is from stagea and ECU too so no TCS) and i dont know for 100% that my car has ABS. It has ABS "cube" in engine bay but i dont think it works(or at least from my braking experience). Can be something like that?  I will be driving the car next week to Nistune tuner to properly see what is wrong...  
    • the Tomei LSD fluid with lsd kit. frustrated that it was shaking the car to crap and affecting everything else negatively, I pulled the diff last night, and removed the lsd carrier, could not find anything wrong, however it seem to be 100 locked up acceleration, and deacceleration, wondering if they sent me a 2 way not a 1.5??  either way I installed the stock open carrier back in place. test drove everything smooth as butter again. no shake, shutter, random, what felt like clutch slip and grab or drive shaft play, etc. something differently wrong in side the lsd. I might bother taking it apart (if possible) to figure out what's going on inside this carrier, as bought too long ago to return.  only draw back is its back to a one wheel wonder.
    • If there's oil in with the clutch, I hope it finds its way out even if that hole has a cover/grommet 😛 I don't want oil near my cars clutch! 😛 Interested to hear the answer about covering it, I'm assuming a bung for a gearbox from another car that has a grommet to suit.
×
×
  • Create New...