Jump to content
SAU Community

Recommended Posts

I am selling the following parts to suit a gtr etc:

-Buddy club Height adj coilovers, very light alloy, excellent condition, suit 32 gtr $800 ono

-Tien HR Height and damper adj coilovers, perfect condition, no leaks, can test in car $900 ono

-Adj fuel reg, mounts to end of standard rail $150

-Mines ECU, runs good afr's $200

-Unichip, complete unit inc loom $500ono

-High mount tubular exhaust manifold, brand new $550

-33 GTR radiator air deflector, covers gap around bonnet latch $120

-RB26 air flow meters inc hks pods - $370 the pair

-32 gtr castor arms w/ aftermarket poly bushes - $100

-OS twin plate clutch, perfect condition, can be installed as is - $800

-Set of gtr rods, perfect condition - $200

-Blank RB26 Head - $500

-33 GTR Brake master cyl, good condition - $250

-32 GTR steering wheel, perfect condition - $250ono

Can supply pics for all parts.

All parts are in Melbourne, but COD etc OK.

Call 0410697349 or email [email protected] for any further details.

cheers.

Link to comment
https://www.sau.com.au/forums/topic/129733-lots-of-gtr-parts/
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

hey mate, can you send pics of the exhaust manifold to [email protected]

let me know if its not t4 flange, as im only interested if its t4 flange.

cheers simon

  • 1 month later...
  • 2 weeks later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
×
×
  • Create New...