Jump to content
SAU Community

Quick Diff Question

limpus
 Share

Recommended Posts

limpus Mentor

limpus

Posted
Posted (edited)

Hey fellas...quick question...i'm looking to get a mechanical diff for my 32 gtst...i was just wondering if the diff centres or housings for the cars with and without abs were different...any input would be much appreciated...cheers...

Edited by limpus
Link to comment
https://www.sau.com.au/forums/topic/130303-quick-diff-question/
Share on other sites
Duncan Grand Master

Duncan

Posted
Posted

but the only difference in the housing is that the ABS onces have ABS sensors on either the yoke (3 channel) or half shafts (4 channel). No problem using an ABS diff in a non ABS car, just cant use a non ABS diif on an ABS car

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • PranK
      Rusty roof repair

      By PranK · Posted

      Thanks. Yeah I realised that there's no way I'd be able to cover the holes with the filler, it would just fall through. Thanks again @GTSBoy!
    • GTSBoy
      Rusty roof repair

      By GTSBoy · Posted

      That was the reason I asked. If you were going to be fully bodge spec, then that type of filler is the extreme bodge way to fill a large gap. But seeing as you're going to use glass sheet, I would only use that fibre reinforced filler if there are places that need a "bit more" after you've finished laying in the sheet. Which, ideally, you wouldn't. You might use a blob of it underneath the sheet, if you need to provide some support from under to keep the level of your sheet repair up as high as it needs to be, to minimise the amount of filler you need on top. Even though you're going bodge spec here, using glass instead of metal, the same rules apply wrt not having half inch deep filler on the top of the repair. Thick filler always ends up shitting the bed earlier than thin filler.
    • Duncan
      New owner from the central coast!

      By Duncan · Posted

      Welcome to SAU, looks like you've picked up a nice one! Any plans to spend more money that you have on it until you hate it?
    • PranK
      Rusty roof repair

      By PranK · Posted

      Also I cut away the top metal that was bent as there's no way I could have gotten it level and the rust stopped. I can also see clean metal under the windscreen. So it looks like this is the extent of it. The lower metal here is also strong.   
    • PranK
      Rusty roof repair

      By PranK · Posted

      Is this ok and then I don't need to patch the holes? Or is it not as good as separate fibreglass repair as well?  https://www.supercheapauto.com.au/p/septone-septone-glass-fibre-filler---500g/3151.html#q=Filler&lang=en_AU&vid=itBd4yPRKxscpBbIMOhvMg%3D%3D&start=10  
×
×
  • Create New...