Jump to content
SAU Community

Recommended Posts

this car had a small hit, its been repaired except for the bonnet ($150), paint on the front ($800 approx) and the aircon needs attention.

98

black

lowered

leather

5 speed manual

89k's

tints

lukey exhaust

rims.

no rego, no plates, can be sold with b/slip if needed.

car is worth $20k with paint and about 18k as is.

will swap for a turbo skyline, or any turbo rwd car, or a gen 3 commodore.

otherwise $12,000 FIRM

the car is in western sydney, call 0439 416 335 to inspect

dscf0709ui9.jpg

dscf0710wn2.jpg

dscf0711se3.jpg

Edited by 98mx5
Link to comment
https://www.sau.com.au/forums/topic/134993-cheap-98-nb-mx-5-convertible-sold/
Share on other sites

Hi mate ( and welcome to SAU),

Are you able to supply more photos - especially from a distance - perhaps side on? also, maybe one of the repaired area ( how hard was the front hit? do you have any invoices for repair work done?)

I was hoping to contact these guys;

http://www.carsales.com.au/pls/carsales/...icle_id=3473361

http://www.carsales.com.au/pls/carsales/...icle_id=3153203

but the fact that you will consider a swap for a RWD turbo is better for me.

Will send you a PM with details for 300ZX TT 5spd targa top, JZA80 1GGTEU and FC RX7 turbo 5spd if these are of interest.

cheers,

J

Hi mate, I've been considering one of these for a while but need more detail. Feel free to send further photos to my email address below. I'd like to see interior as well as under bonnet and around the headlights, and the complete front view.

I have 2 R33 GTS25t Skylines I want to get rid of in the near future.

One is auto and black '94 with 115K on the clock. Stock hand polished wheels and side skirts. Has had a light tap in the side at the rear of the right side but will be repaired in a couple of weeks. I've never taken it over 7psi. Great sounding exhaust from the turbo back so it isn't too loud being an auto. I did have a loud one but it was annoying. All maintenance by myself but it's been so reliable it's only needed belts and oil changes.

The other is a red manual 94 I've used on the track mostly. 128K twin turbo RB25dett. Engine about to be rebuilt with new turbos so not quite available yet. HD Systems height and damping adjustable suspension and adjustable castor as well as about to receive rose jointed rear adjustable camber setup. Diff recently replaced with a good stocker. Pineapples. can come with or without attachments for harness. Made 220rwkw on the single turbo setup with power fc and looking at 280-300 after finished with the TT and rebuild. Lots more to tell but will be looking at around $20K once the work is done on this one though. It will have a tough engine and plenty of power and handling.

If interested let me know.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I wasn’t able to replicate the sound anymore. It was a one time sound so maybe it was just coincidence but it was like small pebbles being dropped in a coke can.   should I try cleaning the MAF? It could be it’s functioning but dirty? I don’t know.
    • Update 4: Hi all. The car drives again! Haven't driven for long, only to store it in the garage again, but the test drive was successful. The coolant and oil leaks seem to be fixed for now. Temps on the engine were also very good, while moving I never even saw 80C water during the approx. 30 minute drive. Ate up all the coolant in the reservoir though so will have to fill that even more when I go to the car next time. One thing that pisses me off is that the RPM gauge is still f**ked, I even resoldered the board twice and used copper paste on the silly screws that are used as connections. Next time I take it out I'll take apart the board and fit new components, I'll see if I can get a replacement IC for it.  I have an appointment set for 22nd of September for the engine tune to 370hp. Alignment also still needs to be done. My hope is that I can get all the legal stuff over with by the end of this season. Anyone of you have advice regarding intercoolers? Currently there is an APEXI core fitted, one of those weird hybrid ones, 600x270x76. I don't think it's bad but it's not new and now I still have the chance to change it now to legally include it in the paperwork. Only issue is that the only options that would arrive in time are a HKS Type R intercooler or generic Ebay spec intercoolers comparable to a JustJap one. Ideally I'd order a Plazmaman but it takes over a month to receive which would mean making the car legal has to wait until next season. Would love to hear some input on this. Same story for my injectors, the previous owner was a nunce and put ID 1050x on the engine. They work but are obviously not ideal at "normal" power levels. But I don't see a reason to change them unless the tuner says it's necessary. I read online before buying a different exhaust that the top secret style rear diffusers won't fit due to the size of the rear resonators. My buddy and I made it work by slightly "adjusting the shape" of the mounting bracket and making some spacers out of 3d print for the mounting bolts. Fits like a charm. Just putting this here in case someone has this problem. Even the hefty HKS Silent Hi Power rear can fits without hitting anything.
    • Well they got my money but they are not getting my gearbox ! 
    • It's needed for rolling idle up, and I think it is a decider on VCT also.
    • I mean, not really. Link ECU's can absolutely still have errors from the ECU thinking it's getting a sensor it's not expecting. I would imagine the speed at the ECU level in Nistune does absolutely nothing anyway? I assume the ECU does not do any fancy TC stuff with regards to front+rear wheel speed or anything of that like anyway. Someone who uses Nistune may be more fluent in it. 
×
×
  • Create New...