Jump to content
SAU Community

Recommended Posts

hi all,

over the next few days im gona be installing my DVD/TV player, sub, amp and rear speakers

im sweet with all the electronics part of it, iv just never pulled apart the console on an R34

just hoping to get some tips/tricks of the trade on the R34 on pulling apart the center console, where to run the cables to the back, etc.

i was suprised that i dont have rear speakers and it doesnt look like theres any speaker cables running back there... is this normal from factory for a GT-T Sedan??

any help will be very appreciated :D

cheers!!

Link to comment
https://www.sau.com.au/forums/topic/136719-stereo-installation-in-an-r34/
Share on other sites

they all have rear speakers. the cables will be tucked away inthe back area.

as for removal of the original, pop the AC vents out - 2 screws, pull ashtray out - 1 screw, pop out panel - 2screws, remove radio.

you will also need an antenna adapter ($15) and harness adapter.($15) to make things work.

if you need these bits fire me a PM ( I sell them.)

  • Like 1
hi all,

over the next few days im gona be installing my DVD/TV player, sub, amp and rear speakers

im sweet with all the electronics part of it, iv just never pulled apart the console on an R34

just hoping to get some tips/tricks of the trade on the R34 on pulling apart the center console, where to run the cables to the back, etc.

i was suprised that i dont have rear speakers and it doesnt look like theres any speaker cables running back there... is this normal from factory for a GT-T Sedan??

any help will be very appreciated :D

cheers!!

Do u have speaker holes on ur parcel shelf??

tanks for that chris rogers,

n15m0 - yes i do have speaker holes in the parcel shelf, and there are the mesh speaker covers too - but no speakers.....???

i'll have a good look for the wiring too, for the rear speakers - im gona try to attempt it all tomorrow...

Also, whats the best way to to run the power for the amp and the remote cable to the boot...??

cheers

My tip is after you pull out the cage holding th stereo be very very careful what you are doing with the back of while all the cables are connected. Heaps of people have scratched the crap out of the plastic surrounds on both sides of the stereo area.

in a sedan- through the passenger foot well.

(jon you can explain it to him.)

Ummm you'd probably do a better job explaining..my amp and power cables only ran as far as under the drivers seat not to the boot. I ran my sub speaker cables from under the drivers seat to the boot. Remove the rear seats, run the cables under the rear passenger seats and thru the middle arm rest hole..

And yeah as Abo Bob mentioned...be careful when removing the facia for the head unit install...mine copped a deep scratch as well :laugh::angry:

ok, cheers for eveything so far......

back seat it out, center console is out....

what was it you said about taking the AC vents out?? are there screws behind there??

and how do you take out the vents... is there a special trick??? im scared if i break em.......

Can you post a pic up of your dvd sreen when your done please,

Thinking of putting a screen in but it looks like when it flips up it will hit the vents etc. because the headunit area sits a fair bit in.

Cheers

Josh

Can you post a pic up of your dvd sreen when your done please,

Thinking of putting a screen in but it looks like when it flips up it will hit the vents etc. because the headunit area sits a fair bit in.

Cheers

Josh

it will if you put it on top. put it on the bottom and it JUST clears. need a pocket to fill the void.

ok,

I hadn't had a chance to instal my system yet...

i started playing this morning, plugged the harness i got from chris (thankyou chris!! :O )

and now i have no power at all, no constant, acc voltage at all, dead to the world!!!

i checked this with my multimeter.....

checked the fuse - its fine!

all i did was take out the standard deck about a week ago - now when i plug the standard one back in, it doesnt work either....???

any ideas?? :laugh:

I got my head deck put in the top DIN spot. it does block the vents a bit, but i can adjust the angle of the screen so that it does not go back far enough to hit the temp dial. Here are a few pics of mine.

headdeck1.jpg

headdeck2.jpg

headdeck3.jpg

enjoy :)

Edited by Vermin

ok, found the problem.... long story short, dodgy multimeter!!! lol (thats why you dont buy cheap ones... lol)

and yes i did throw it against a wall!!! lol

next question, is there a factroy hole in the firewall somewhere where i run the power cable for the amp?

and the parcel shelf - how do you take it out? I have these wierd metal brackets right across the speaker holes and they gota go if im gona put speakers in there.

I found the rear speaker cables, they were hidden near the speaker holes and sticky taped ;)

Im planning on finishing this today so i'll post up some pics once its done!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I would just put EBC back on the "I would not use their stuff" pile and move on.
    • Can I suggest you try EBC directly again and link them to as many competitor catalogues as you can to show their listing is incorrect, eg https://dba.com.au/product/front-4000-series-hd-brake-rotor-dba42304/ If you have access to an R33 GTST VIN and your VIN, you could also use a Nissan Parts lookup like Amayama to show them the part number is different between 33 GTST and 34 GTT which may get their attention
    • So i got reply from EBC and they just this site where you can clearly see those 296mm fronts on R34 GTT. I send them photos and "quotes" that 296mm are not for 34 GTT and they are too small. But it will be very hard to return them cuz nobody here knows 100% and they just copy those EBC catalogue :-D https://ebcbrakesdirect.com/automotive/nissan/skyline-r34
    • Hi, is the HKS  Tower Bar still available ? negotiable ? 🤔
    • From there, it is really just test and assemble. Plug the adapter cables from the unit into the back of the screen, then the other side to the car harness. Don't forget all the other plugs too! Run the cables behind the unit and screw it back into place (4 screws) and you should now have 3 cables to run from the top screen to the android unit. I ran them along the DS of the other AV units in the gap between their backets and the console, and used some corrugated tubing on the sharp edges of the bracket so the wires were safe. Plug the centre console and lower screen in temporarily and turn the car to ACC, the AV should fire up as normal. Hold the back button for 3 sec and Android should appear on the top screen. You need to set the input to Aux for audio (more on that later). I put the unit under the AC duct in the centre console, with the wifi antenna on top of the AC duct near the shifter, the bluetooth antenna on the AC duct under the centre console The GPS unit on top of the DS to AC duct; they all seem to work OK there are are out of the way. Neat cable routing is a pain. For the drive recorder I mounted it near the rear view mirror and run the cable in the headlining, across the a pillar and then down the inside of the a pillar seal to the DS lower dash. From there it goes across and to one USB input for the unit. The second USB input is attached to the ECUtec OBD dongle and the 3rd goes to the USB bulkhead connected I added in the centre console. This is how the centre console looks "tidied" up Note I didn't install the provided speaker, didn't use the 2.5mm IPod in line or the piggyback loom for the Ipod or change any DIP switches; they seem to only be required if you need to use the Ipod input rather than the AUX input. That's it, install done, I'll follow up with a separate post on how the unit works, but in summary it retains all factory functions and inputs (so I still use my phone to the car for calls), reverse still works like factory etc.
×
×
  • Create New...