Jump to content
SAU Community

Recommended Posts

Hey guys I ran my car last Friday at Calder backed of at say 5000rpm in first gear coz it bogged and held back.

Initially, I assumed I had a vaccum leak from were i plumbed my blow off valve from. Cant be fuel supply coz I had a full tank.

However, after removing the tube and returning the blow off valve set up back to atmospheric It bogged a little again. It only happens when Im hard on the throttle every now and then. Some times its cool and sometimes it decides to bogg.

It made 211.8 rwKW on 14psi at C&D with a dump back exhaust (no cat), SAFC, APEX fmic, fuel pump. Car showed no signs of problems on the dyno. It made 193 rwKW on 8psi. Will post dyno graph shortly.

Need to know before Friday coz im running it again at Calder. Any info will be most appreciated.

PS plugs are gapped at 0.6mm, motul turbolight and use BP ultimate.

Any ideas what i should expect from 1/4 mile time and mph. (Using standard suspension and street tyres.)

.6 is far too much, should be no more than .8

If you need to go to .6, you probably have a coil issue, or plugs arent good condition

As for times, 105mph @ 13.5 is my stab for around the 190-200rwkw mark, bein you do have a stock turbo...

And i wouldnt be using 14psi. Its really pointless IMO.

Go back to 10-11psi, will save the turbo from dying aswell.

I ran 12.9 @ 109 in 225s with 215-220rwkw :ermm:

My mate has 235rwkw 12.4sec 1/4mile and runs the same plugs with 0.6mm gapping and has never had a problem. btw the plugs in my car are brand new. Just to remind you... there were no signs of problems in ignition or fuel supply on the dyno.

Any ideas on my suspension set-up?

Thanks in advance.

So what if he didnt have a problem?

Are we talking about your mate and his or your car here dude? :D:ermm:

Things might well have been fine on the dyno, but they (obviously) arent now are they? :sorcerer:

Plugs being new doesnt mean a lot when the gap indicates you have ignition issues if they are gapped down that far, hell... i was running 24psi, 269rwkw and race fuel and i didnt need them gapped that small.

No-one is going to have a magical answer for you, it could be lots of things, ignition is the place to start however.

As for your suspension, you have what you have is not going to affect times greatly when you have what is essentially a stock car

It will come down to driver/launch/tyres more than suspension at this stage of the game... plus tyres are cheaper, and expirience is free.

So again, my prediction above of 13.5 @ 015mph stands... if you cant drive, closer to 13.8

Reducing your plug gap to 0.6mm is only hiding your miss. You have a problem with it so you need to fix it. Reduce your gap will fix it, but your performance will suffer slightly. Your call.

I had the same problem and had to reduce the gap to 0.65mm , then i bought some spitifires and now run them at 0.85mm gap with alot more boost, no misses what so ever.

Hey guys I ran my car last Friday at Calder backed of at say 5000rpm in first gear coz it bogged and held back.

Initially, I assumed I had a vaccum leak from were i plumbed my blow off valve from. Cant be fuel supply coz I had a full tank.

However, after removing the tube and returning the blow off valve set up back to atmospheric It bogged a little again. It only happens when Im hard on the throttle every now and then. Some times its cool and sometimes it decides to bogg.

It made 211.8 rwKW on 14psi at C&D with a dump back exhaust (no cat), SAFC, APEX fmic, fuel pump. Car showed no signs of problems on the dyno. It made 193 rwKW on 8psi. Will post dyno graph shortly.

Need to know before Friday coz im running it again at Calder. Any info will be most appreciated.

PS plugs are gapped at 0.6mm, motul turbolight and use BP ultimate.

Any ideas what i should expect from 1/4 mile time and mph. (Using standard suspension and street tyres.)

In summary, 212 rwkw and an SAFC with the standard turbo.

Night time, colder (denser) air compared to daytime, hotter air on the dyno.

My first guess would be that the standard ECU is getting into R&R mapping because of the increased airflow.

My suggestion would be to ake it back to your tuner and tell him what is happening. He may be able to sneak a bit more corection into the SAFC to allow for the night time running

OR

Wait unilt summer before you run it at night time drags.

:P cheers :huh:

  • 2 weeks later...

Yeah ran again the following friday.

14.2sec @ 100.9mph @ 8psi

13.8sec @ 104.9mph @ 10psi

13.9sec @ 105.5mph @ 12psi

13.7sec @ 104.8mph @ 11psi (this last run i plumbed my blow offf valve back whilst waiting in line)

My 60ft times were shocking they ranged from 2.3-2.6secs. My tyres let me down they were only 25/225's and hard compound. So in regards to my mph im guessing a low 13 with good traction.

I did hit R/R mode about three times but once I put my headlight back in place it ran fine.

One thing im worried about is that whilst burning up the tyres before my run i noticed that my rev limiter does not exist. My leg was still flat on the throttle and somehow i pushed the clutch in at the same time (dont ask why i was nervous!!!) so thereby placing it in neutral; my revs went all the way to 9000rpm.

Any idea to wether or not my engine has been rebuilt in japan? Or am i dreaming? Im guessing when the SAFC was installed by the previous owner in Japan they removed the limiter. But it must be for a reason!

Now, should I opt for a PFC first or a Turbo upgrade (thinking of something with response say GT2871R with 0.86 exhaust A/R) ?????

Thanks you to all in advance.

Bill

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...