Jump to content
SAU Community

Recommended Posts

235/45/17 has a massive range of tyres, and they are quite well priced due to the massive popularity.

They are also the size of a control tyre for one of the motorsport events, so its relatively easy to find new and second hand Comp-Rs in that size.

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

I'd have to agree with that

Semi's are probably fine for the street 98% of the time, but the other 2% (Or maybe 1% at the moment with this drought) when you have some serious rain they would be downright dangerous.

Best to go for something that's a bit more of an all rounder.

any idea what semis in that size go for?

I bought second hand Advan A032Rs in 235/45 R17 for under $100 a pop. Mind you, they were very second hand. Track days only, and only if you're not doing competitive motorsport. On the plus side they never overheat and even after a couple of track days / supersprints they don't look any more worn than when I got them.

If you buy brand new RE55S, A032Rs, R888s, etc you're looking at $450 a corner.

Being a street car, i wouldn't want to run semi's on it.

I wouldn't recommend it, either. I've driven on Comp-R semis as daily driven tyres, and since it was winter it was one of the scarier times of my life. In the wet I may as well have been on ice....and what do you know it was always raining.....

I would suggest keeping your OEM rims. Find good tyres that are as wide as possible that will fit your rims while retaining the OEM rolling diameter.

Check the tyre thread for feedback, and then see what falls into your budget.

Well I wouldn't put 225/50 on a 6.5" wheel... but Yokohama thinks it is ok (6.0-8.0)

Mind you my car has 215/45R17 on 9J (7.0-8.5 recommended)

http://www.yokohamatire.com/utrimwidth.asp

Choosing a wheel near the middle of the range will give a balance between ride quality and handling. A wider wheel will improve handling at the expense of ride quality, while a narrower wheel will improve ride quality at the expense of handling. Consider these compromises when selecting wheels.

So the answer is YES, or NO... depending on what you mean by better or worse :)

Edited by Laurence

tyreflex

less tyre flex makes it more uncomfortable but makes the car a lot more predicatble.

but once you start stretching tyres enough, you are sacrificing the amount of tyre you are gettin onto the road for small difference in tyreflex.

most people do it for the look

Edited by salad

Just to add my experiences:

1. 265 wide FALKEN 326(SHIT TYRES) on 18 x 9inch rims like NEW! 95%+ thread <265/35/r18>

2. 205 wide Dunlop Sp2050(OEM Accord Euro Tyres) 30-40% thread just above wear indicators on Stock 16 x 6.5inch rims.(r33gtst) <205/55/r16>

Car with 200rwkw. R33 gtst.

1. Around Wakefield i managed the same time around the track both 1:18 BACK then (1:16's now).

2. Traction wise, i was surprised some quality dunlop tyres with only 30-40% thread GRIPPED better then my near new 265 falken tyres. 95%+

3. Compared to my 225/50r16 falken 326(compliance tyres that came with car). the 205/55/r16 dunlops is 100 TIMES BETTER.

So for me, QUALITY tyres OVER WIDER tyres.

<btw my mate just picked up some Toyo T1R's a few months ago in 205/55/r16 for $170-180/tyre> for the 225/50/r16 is was like $210 or there abouts.

thats just my 2cents.

salad... could you explain the theory on less contact on the road.

Does the tread go concave or something along those lines?

when you're stretching a tyre on a rim, you are using a skinny tyre that is too skinny for the rim. ie, not very wide. so you could get a much wider tyre on such a rim.

just a commonly used example, a lot of people stretch 215/45R17 on 17x9, ive done this too. now, with a 9" rim you can fit 255/40R17 on there no worries. now going by the rule of thumb that the width is in mm, you now have ~19% more rubber on the ground. thats a fair bit!

given you will have a bit more flex as the sidewall is slightly taller (5mm) and you arent stretching it, but i would rather go for the more grip personally. even for drift, means you have more grip and can go a lot faster, and hold bigger entries.

on standard rims i've run 225/50 and 205/55, and i liked the 205/55s much better. given it probly wasnt a fair test because i ran good yokohamas in the 205/55 and run of the mill 225/50s, but the 225/50 just felt a lot sloppier

Edited by salad

the contact patch thing is a myth. force is pressure times area, and the pressure a tyre can exert on the road is equal to its internal air pressure. therefore no matter what shape of tyre (wide or skinny) you will have the SAME area on the road.

However, a wider tyre will have a wider patch and a skinny tyre will have a longer patch. wider patch is better for cornering grip, skinnier patch is better for driving in the wet as there is less water to push out of the way.

the contact patch thing is a myth. force is pressure times area, and the pressure a tyre can exert on the road is equal to its internal air pressure. therefore no matter what shape of tyre (wide or skinny) you will have the SAME area on the road.

However, a wider tyre will have a wider patch and a skinny tyre will have a longer patch. wider patch is better for cornering grip, skinnier patch is better for driving in the wet as there is less water to push out of the way.

Yep got that idea now. because the tyres still have the same amount of weight pushing down on them. A skinny tyre will have a more square shape contact patch, whereas a wider tyre would have a rectangle one.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
×
×
  • Create New...