Jump to content
SAU Community

Recommended Posts

Hi ppls,

Over the last few weeks I've been experiencing the occasional lean conditions; sometimes when I first start the car other times just out of the blue.

The car will be driving fine then all of a sudden I notice a slight surging at light/moderate throttle and a rough idle; check the pfc's sensor check and see the o2 sensor going lean.

Driving the car it tends to surge a little and feels as if it has a bit of a flat spot at the start of the throttle.

It used to come good once getting up on boost.

A simple pull over and shutdown and restart 9 times out of 10 would get it going smooth again.

Now (today) it began going lean once up on boost and also knocking easy.

Nothing I could do would get it driving nicely again; it would however come and go as I drove; lean then it would smooth out and afr's would return to normal.

All sensors (afm *that is/was new* etc) check out and are reading as they usually do, apart from the o2 obviously.

The external bosch pump appears to to be buzzing away as it usually does however the intank std pump that is well overdue may be failing.

Could the intank pump have failed causing a restriction to the external fuel pump? I'm not sure if that is possible. Maybe...

Do note that I threw the external pump on the car as the std pump couldn't keep up with only 150rwkw at the wheels when the RB20DET was in it running 12psi. That was ermm..... Over 130,000km's ago.

So....... Any one had an experience similiar? The come and go surge/lean conditions that progressively get worse.

I'm going to look at the pump first; if its not that then my first place of call is the PFC. Just a gut feeling.

Link to comment
https://www.sau.com.au/forums/topic/139287-bosch-fuel-pump-lifespan/
Share on other sites

if you've still got the stock lift pump, then i'm gonna say that its probably at the end of its long life....

My hopes it is also... and not one of those expensive hard to track down bugs. :dry:

are u running with 02 feedback on or off? have u changed the 02 feedback co-efficient?

I've tried with with both; haven't changed the o2 feedback co-efficient.

I've init. the pfc and simply selected vg30 maf and applied inj correction. Still the same. :(

I'll rip off the intanks plate tomorrow and see if I can hear the intank pump working.

Fingers crossed it isn't so its an easy fix. :)

I just came back from a drive then... Its really strange; cold start it was good, 1km down the road it started surging; pulled over did the pfc reset; drove off it was ok for 500m then began playing up again. 10km's later and it came good for another 5km's then went to crap again.

Some times on cruise it will go lean; accelerate a little and it comes up and the o2 begins cycling again; back off slightly and it goes lean. But note that is some times.. Othertimes it simply stays lean then gradually becomes richer again.

Whats strange is if I were to give it a bit it doesn't completely go lean it surges a little then takes off, but I suspect it is going lean a tad as it does tend to det a tad.

Which isn't good. :P

Hope that made sense. lol

From your details it sounds like it could be the stock lifter has shat itself but it could just as easily be the Bosch item from experiences I have seen.

My best mate has a full tilt turbocharged Holden rodeo V6 ( turbonetics Y2K) and it has had more than one bosch pump fail. And they were not by any means long in the tooth. He has now resorted to using 4 of them with allowance for two of them to die on a dyno pull/drag run and still be safe.

From what he,the builder and the tuner have diagnosed is that the bosch pumps, although being very capable of supplying fuel are very very susceptible to failure from any type of foreign matter that may pass through them which is what they have put the failures down to. Hence there are now filters before the pumps.

Not sure if it has any bearing at all in your situation but just thought I would add it as I have indeed seen bosch pumps fail early in there life. ( to Boschs credit, they were all replaced without question)

Thanks FatGTS-R.

The pump is what I would consider long in the tooth. Its around 4.5yrs old and as mentioned around 135,000km's old, well maybe closer to 145,000km's. :dry:

Tomorrow I'll ensure the turbo to afm pipe isn't split or leaking as I'm sure this could also do what I am experiencing.

If your suss on the intank than I would fix it real quick as if it is not supplying pressure to the back of the bosch then you might be up for two pumps!!

And as for bosch pumps not liking foreign matter - no pumps like it, however I still believe the bosch will handle it better then most others.

Well this is going to be one of those niggly problems thats difficult to get to the bottom of.

I had a fiddle with it today and and its almost normal.

Idle is now fine but partial throttle cruise goes lean to the point where the o2 sensor can't pull it back in; slight throttle to accelerate the car has the o2 sensor flicking againl or with the feedback off has the sensor reading from 0-0.04v to the usual 0.9v.

I've disconnected the external pump and had the stock pump blowing through the disconnected external. The fuel pump appears to still be working fine as there was no difference with the external connected or not.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
×
×
  • Create New...