Jump to content
SAU Community

Recommended Posts

I have a s13 with an rb26 engine. big single turbo, apexi pfc, 300zxafm, 260cams etc...

I am having a problem with the engine at the moment.

I pulled it hard in first and second gear, and all of a sudden, the engine lost power.

idling is fine, no leaks, changed the plugs to see if they where blown but with no luck.

its fine driving at low speeds aswell, but when it starts building boost at 3000-3500rpm things just bow down.

the air/fuel is going ritch, and lots of black smoke comes out...

right now im thinking there is something wrong in the ignitionsystem.

it seems like its not firing at all on load. tried to release the pedal a bit too, but the same things happens.

have anyone here had similar problems vith their rb26 engines?

its REALLY boring to drive it now....

any help is mutch apprechiated!!!!

Link to comment
https://www.sau.com.au/forums/topic/140409-s13-rb-26-engine-problems/
Share on other sites

I have a s13 with an rb26 engine. big single turbo, apexi pfc, 300zxafm, 260cams etc...

I am having a problem with the engine at the moment.

I pulled it hard in first and second gear, and all of a sudden, the engine lost power.

idling is fine, no leaks, changed the plugs to see if they where blown but with no luck.

its fine driving at low speeds aswell, but when it starts building boost at 3000-3500rpm things just bow down.

the air/fuel is going ritch, and lots of black smoke comes out...

Its very hard to try and diagnose over the internet. But I doubt it would be an ignition system problem. You have 6 coilpacks and I would think that it would be rare to lose all six at once. I would be looking at the air side of things - e.g. Air Flow Meter, BOV leaking. Have you got a gauge monitoring your boost pressure in your intake manifold? Just check it to see what may be going on.

Its possible the timing has adjusted? Could be one of many things.

Cheers

Sumo

check your cooler pipes. i had something similar a while ago. it would idle like there was no problem at all, but come onto boost and the cooler pipe would be pressurised and i started to leak near a clamp.

cheers

Jeremy

check your cooler pipes. i had something similar a while ago. it would idle like there was no problem at all, but come onto boost and the cooler pipe would be pressurised and i started to leak near a clamp.

cheers

Jeremy

I was about to type the same thing.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
×
×
  • Create New...