Jump to content
SAU Community

Recommended Posts

The problem with my Afm required it to be internally repaired (the solder joints on the inside of the plug to the afm's circuit board Under that square black cover) a clean wont do unfortunately.

It would be better for you to swap it with a known good working unit to test.

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-300305
Share on other sites

i spoke to dr-drift aka sam and hes on to something, he said that maybe theres a problem with the solinoids that are on the hicas steering,now that would explain why it only does it to the left, maybe theres a short or it robbing power away from the fuel pump??? sound logical

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-300314
Share on other sites

well i unpluged the computer under the parcelself and it still did it,and i think the hicas system is hydraulic. Sooo where do i go from here??? now i know it doesent do it in reverse on when u go forward,and it even does it when you going walking pace to the left, soooo maybe its some sensors somewhere, is there any sensors in the steering rack????? also when u hear backfiring noise that mean rich fuel mixtures cause thats what its doing after the steering wheel goes back to straight, which make me think that maybe its not playing with fuel pump but maybe spark??? does that sound right???

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-301226
Share on other sites

Sounds like something to do with the fuel pump..or even something silly like fuel line being twisted or pinched or something as you turn. Check your fuel filter as well, can't hurt to replace.

Backfiring is overly rich yes.. i get it with low-grade fuel sometimes as well.

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-301267
Share on other sites

The skyline fuel filters are replace type only Z200 I think.

You in your profile state your car is an r31 coupe is this the Rb20 equiped model? if so on the drivers side of the engine bay is all the soildnoids and hydrolic sensors May be you could un plug them an see if the car still plays up also thats the same side as the fuel lines check as someone else stated that the fuel line is not fouling with the steering rack(getteing pinched) . Still dont rule out the Afm until you have swapped it with a known working unit.

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-301784
Share on other sites

well i changed the sparkplugs and its kinda better now,but i found that the 2 plugs that go into the igniter box thing at the back of the engine,when i fiddle around with them then it stops, i tried to do some fixing to the plugs but its a no go,so which makes me now think its the igniter pack thing, does this thing stuff up much???

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-304315
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I dunno about that as a blanket statement. Pitwork is Nissan's "Nissan genuine" thing, and for stuff like timing belts, I have found them to be excellent. Of course, for things like oil filters, you always use proper trusted brands anyway, not whatever the OEM has taken to using.
    • Ahhhh... If you were putting 12V to the led in there, that's likely made it very unhappy. Chances are how you put power, was 12V across an LED that's meant to only have about 20mA through it at peak, and a forward voltage of about 1.8 to 2.4 volts. That circuit is likely only a 3V3 circuit, and will have a resistor in series with the led too. That's my guesstimate on that light, without having touched one.
    • Another vote for installing them and see how you go.  I mean, you already own them, why would you not fit them? 
    • I have had too many of those over the years, my cars have a toolkit or at minimum a cheapy multi tool thing because its too easy to be snookered by some stupid plastic clip that stops you checking the battery terminal isn't loose.
    • Basically, if there is a part# on the nissan catalogue, it is a genuine part. There is a thing called "new old stock" which is stuff made years ago but never sold (or landfilled), but it is super hit and miss what you can buy. Other than some expensive Nismo stuff there is nothing new being made that suits these cars. The only time to be a little careful is (mostly in the US I think, but maybe Japan too), Nissan started rebranding some cheap crap maintenance parts like oil filters as "Pitworks"; stay away from them, if you are buying cheap just buy whatever the local car parts shop carries The three part numbers have an explanation on Amayama: 0V005 is auto, base style 0V015 is manual 0V505 is auto, hectic momo branded ones, maximum F&F points there!
×
×
  • Create New...