R33 Gtst Box Push To Pull Conversion

[SirRacer]

Hey there,

I have a r33gtst box with broken input shaft housing and are contemplating converting it to pull clutch as i can get a cheap twin plate pull clutch.

Ive read a similar thread but re a gtr where a poster said "yes you can. If you dont want to change to a pull type clutch just redrill the holes for the slave cylinder and tap them and the slave will bolt straight on. There are 2 spots on the R33 box for the new holes. Then swap the front end of your box onto the R33 box and use the old push clutch fork and bearing. Its a very simple job.

When swapping the front of your box over be sure to use some grey sealer on the bottom bolts as they help seal thhe box from the bell housing"

From what ive been told you need to change some bearings etc.

Can anyone elaborate>?

Thanks

Byron