Jump to content
SAU Community

R33 Gtst Box Push To Pull Conversion

SirRacer
 Share

Recommended Posts

SirRacer Experienced

SirRacer

Posted
Posted

Hey there,

I have a r33gtst box with broken input shaft housing and are contemplating converting it to pull clutch as i can get a cheap twin plate pull clutch.

Ive read a similar thread but re a gtr where a poster said "yes you can. If you dont want to change to a pull type clutch just redrill the holes for the slave cylinder and tap them and the slave will bolt straight on. There are 2 spots on the R33 box for the new holes. Then swap the front end of your box onto the R33 box and use the old push clutch fork and bearing. Its a very simple job.

When swapping the front of your box over be sure to use some grey sealer on the bottom bolts as they help seal thhe box from the bell housing"

From what ive been told you need to change some bearings etc.

Can anyone elaborate>?

Thanks

Byron

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • funkymonkey
      Howdy Y'all

      By funkymonkey · Posted

      Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Dose Pipe Sutututu
      Starting again

      By Dose Pipe Sutututu · Posted

      Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
    • R33_Guy
      Speed Sensor replacement

      By R33_Guy · Posted

      Thank you so much for the help
    • GTSBoy
      Speed Sensor replacement

      By GTSBoy · Posted

      Yes it is ATF. I quote @Duncan "it takes a good synthentic auto trans fluid like Castrol Transmax Z" It's not a diff. It's a transfer case. Totally different thing. Yes, fluid will come out the sender hole. No you do not really need to drain it. Just pull the old, quickly poke the new, clean up and top up. But realistically, you should probably take the opportunity to change it anyway.
    • R33_Guy
      Speed Sensor replacement

      By R33_Guy · Posted

      Hey all. I’m looking on replacing my speed sensor on my R33 GTR. Will the center differential need to be drained, and if so, the center diff uses ATF fluid D? I found information on the transmission, front diff and rear diff. Can’t find a for sure answer for the center diff. Any help will be greatly appreciated.
×
×
  • Create New...