Jump to content
SAU Community

Wat Power Am I Lookin At?

cattivo_69

By cattivo_69,
in Engines & Forced Induction

 Share

Recommended Posts

cattivo_69 Community Regular

cattivo_69

Posted
Posted

Hi guyz

Looking at putting a Power FC into my r32 rb20

mods are as follows

Cold air intake

Full turbo back exhaust (hi-flow cat and dump)

FMIC

GTR fuel pump

wat sort of power (kw) roughly should i get?

i understand that u cant boost 2 much with standard turbo but just want a rough ball park figure?

thanks

Link to comment
https://www.sau.com.au/forums/topic/148489-wat-power-am-i-lookin-at/
Share on other sites
paulr33 Grand Master

paulr33

Posted
Posted

max power isnt always that important, its average power and how the car drives. with stand alone (or a full remap) you can add in a bunch if ign timing on the load points and the car really comes alive. it will drive like a different car once all the load points have been set.

the beauty with the FC is that you can do it yourself on the hand controller

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Murray_Calavera
      R33 Fuel Pump & Brakes after alarm swap

      By Murray_Calavera · Posted

      Did you pay with a credit card? I'd be putting a charge back through then finding a new sparky to sort it out. 
    • Jarsky
      R33 Fuel Pump & Brakes after alarm swap

      By Jarsky · Posted

      If you mean the alarm immobiliser; theyre internal to the alarm itself which makes that difficult; I couldnt even see where he put it; its not in the same place as last time; but with all black wiring it might be very challenging to trace  I had someone turn the key for me as I know it only primes for a couple of seconds As my post above; I am getting no voltage to the pump at all; but I am testing continuity of the power line (SB) from the pump plug to the relay fine. As well as the negative from the pump plug to a 12V constant.    Yeah; he blammed the no start on a bad battery; said I needed to get a new battery and it'll start. Turns out the battery drained because the tail lights had been on for half the day during the install (the rubber cushion on the brake switch gave out while he was testing it as I have a picture of the car from that morning with the tail lights off..i've replaced that). The battery was turning over the engine just fine for a long time; but got low since lights were draining it so it was too low to test a start after he finished. I bought a new one on his advice...$250 wasted. My original battery charged up just fine and is healthy.    It was running perfectly fine when I messed up the old alarm (programmed out the remotes). He couldnt start it after removing the old alarm; my assumption is that when he unhooked it; he didnt bridge the circuit back when trying to start it. Its always been perfectly fine. The ECU swap and pump were 2 years ago. It's never missed a beat in that time. 
    • PranK
      My BMW 335i

      By PranK · Posted

      This is a big issue for me without the diff. I just have zero drive from the passenger side when drivers side has no traction. Bec's parents place has a crazy steep driveway with odd camber and I have never been able to get up. My bro-in-law's 130i with an (unknown brand) LSD gets up fine as does their dad's Hiace. My car stays at the bottom. We have other odd camber roads around here as we're elevated a bit and if it's raining I can get totally stuck around some hairpins. 
    • PranK
      My BMW 335i

      By PranK · Posted

      Yeah, I am super excited for this.
    • Murray_Calavera
      R33 Fuel Pump & Brakes after alarm swap

      By Murray_Calavera · Posted

      Was the car running before he touched the car?
×
×
  • Create New...