Jump to content
SAU Community

Recommended Posts

I posted this in Specific Auto discussion, but i know there are some wise SA people who don't alway check in there so i thought i would try my luck here too.

So i think i have a coil pack problem, i did a quick search through the posts on here and it seems as if this is the go but i thought i would just make sure and ask others if they had the same things happen.

This has only happened to me twice, both in the last month. The first time i had just got out of the drive way and all of a sudden the TCS and SLIP dash lights came on as did the check engine light. The check engine light went off, but TCS and SLIP stayed on. The car still drove fine, so i got where i needed to go and then shut the car off. When i came back to the car i turned it on and it started no problems, but the A/T (Auto/triptronic) light started flashing, it flashed a number of times and then went off. After that i drove the car around no worries then yesterday i got in the car turned it on, reversed down the drive way and as i reached the bottom the TCS and SLIP lights came on again and stayed on, and the check engine light came on and then went off. I drove the car back up the driveway and turned it off. I then turned it straight back on and the A/T light flashed a number of times (16 i think i counted). I turned it off, then back on and it started fine, no warning lights at all.

As i said i think it is a coil pack problem from what i have read, the car is going in for a service Wednesday (in 2 days) so i want to get the problem fixed then. So i'm just making sure this is the problem and that others had the same type things happen to them. Also how did others work out which coil was bad?

*****EDIT******

I ran a Self-Diagnostic and got Error Codes

26 -----Turbo Pressure Senor Signal Circuit: Turbo pressure sensor output voltage is aprox 4.8V or greater open circuit or less than 0.06V closed circuit for a predetermined time.

43----- Throttle Position Sensor Signal Circuit: Throttle position sensor output voltage is aprox 4.7V or greater open circuit or less than 0.06 short circuit for a predetermined time while park/neutral position switch is OFF and vehicle speed is 4 km/h or higher.

So aparantly these are my problems, but i have also heard of people having coil pack problems and the 21 code not showing up and them getting other fault codes instead. Yet when the coils were changed the other issues went away. Has anyone had these fault/error codes on there 34 before?

Cheers

Sean

Edited by mxtcy

Hi Sean,

I know at least on the CA18DE that the warning lights come on when your engine misfires from a coil. Not sure about the RB motor though - is it running really rough when the lights come on? Is it just on idle or when you apply throttle? One way to check, providing it does it on idle, is removing the ornament cover and looking for stray sparks under the coils. If it's doing it on higher rpm's, then you'll probably need a spare coil and replace them one at a time.

Best thing to do from time to time, even if you don't have any coil problems, is to remove the coilpack, clean up the tips for any carbon deposits, then silicone spray the inside of the boot and the coil body.

Hope this helps.

Cheers

Howie

I had the problem myself last week in my 32. We took the ornamental cover off, started the engine (Make sure its cold and problem is present), then one at a time unplug a coil. If the motor goes slugish, then that coil is not the problem. Do it until you unplug one that makes no difference to the idle. Turn off engine, take out the coil and more than likely you'll find it has arc'd out or the like. Had 3 go in mine, wasnt nice :)

I ran a Self-Diagnostic and got Error Codes

26 -----Turbo Pressure Senor Signal Circuit: Turbo pressure sensor output voltage is aprox 4.8V or greater open circuit or less than 0.06V closed circuit for a predetermined time.

43----- Throttle Position Sensor Signal Circuit: Throttle position sensor output voltage is aprox 4.7V or greater open circuit or less than 0.06 short circuit for a predetermined time while park/neutral position switch is OFF and vehicle speed is 4 km/h or higher.

So aparantly these are my problems, but i have also heard of people having coil pack problems and the 21 code not showing up and them getting other fault codes instead. Yet when the coils were changed the other issues went away. Has anyone had these fault/error codes on there 34 before?

It actually sounds to me like your throttle position sensor may be up the creek mate. The TPS is linked into the auto trans & traction control systems so there's a good chance that may be the problem.

I'd be looking at other things first besides the coils if you are not having any problems with the way the engine is running. Does it go ok on full throttle both from low revs & on max boost? If it does I'm a bit doubtfull about it being coils.

The TPS may even just need a slight adjustment.

The turbo overboost could be attributed to the exhaust & front mount if the sensors maximum isn't very high. I'd say it's likely irrelivant to your problem.

Edited by JazzaR33

Yeah could even be just a dodgy connection if it's not faulting all the time. Or if it's the TPS & it's just slightly worn in a couple spots it may play up intermittently.

Will be interested to see what they find

Yeah could even be just a dodgy connection if it's not faulting all the time. Or if it's the TPS & it's just slightly worn in a couple spots it may play up intermittently.

Will be interested to see what they find

Results are in....

... car is perfect!

Mechanic said its nothing to worry about as he couldn't find anything at all wrong with the car.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I don't know it is due to that. It could just be due to load on track being more than a dyno. But it would be nice to rule it out. We're talking a fraction of a second of pulling ~1 degree of timing. So it's not a lot, but I'd rather it be 0... Thicker oil isn't really a "bandaid" if it's oil that is going to run at 125C, is it? It will be thicker at 100 and thus at 125, where the 40 weight may not be as thick as one may like for that use. I already have a big pump that has been ported. They (They in this instance being the guy that built my heads) port them so they flow more at lower RPM but have a bypass spring that I believe is ~70psi. I have seen 70psi of oil pressure up top in the past, before I knew I had this leak. I have a 25 row oil cooler that takes up all the space in the driver side guard. It is interesting that GM themselves recommend 0-30 oil for their Vette applications. Unless you take it to the track where the official word is to put 20-50w oil in there, then take that back out after your track day is done and return to 0-30.
    • Nice, looks great. Nice work getting the factory parts also. Never know when you'll need them.
    • Thanks @jtha7 I will have a look around tomorrow but it is a prick of a spot. These are some photos i tried taking 
    • I take it that the knock retard is from bearings tapping a little tune? Thicker oil is a fragile bandaid. You need a much bigger oil cooler and probably the bigger pump being discussed.
    • Hi @Chupapy i had several leaks from coolant pipes being corroded, i also had one leak on back of the head onto transmission. For me that leak was from the turbo water line. Follow the line to the back of the head The hose and metal pipe had perished these are the best pics I took of it at the time
×
×
  • Create New...