Jump to content
SAU Community

Closed

IanB

By IanB,
in Events

 Share

Recommended Posts

  • Replies 166
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Posted Images

phatboi2010 Grand Master

phatboi2010

Posted
Posted
guys...

Good to see more people coming, but I hate to be the forum troll on this one, but can we keep this remotely on topic?

Kthx...

Ian you old prude.... Bring on the hot bitches :no:

so are we gonna do dinner first?? was good last run...

Link to comment
https://www.sau.com.au/forums/topic/153441-closed/page/3/#findComment-2866060
Share on other sites
Draen Enthusiast

Draen

Posted
Posted (edited)

Im up for a feed before the run. Also would be good to put some faces to the cars before hand, since I'm new. So anyone up for a bite to eat at the Gap Village, say at 7pm? (This is pretty much on the way to the Mt Nebo run - its on Waterworks Rd). There is a coffee Club there, Maccas, and a Cafe at the very least.

For the regular Mt Nebo runners, where do you guys normally meet up before heading together up to Nebo? A Dead end road somewhere or BP on waterworks road, depending on numbers?

So first proposal - meet up at 7 at The Gap Village Coffee Club.

The Gap Cafe Bar Restaurant

Shop 30, 1000 Waterworks Rd

THE GAP QLD 4061 - (07) 3300 6782

Open to alternative ideas.

Edited by Draen
Link to comment
https://www.sau.com.au/forums/topic/153441-closed/page/3/#findComment-2866218
Share on other sites
IanB Veteran

IanB

Posted
  • Author
Posted

List updated.

Generally I like to meetup on the southside at springwood then the northside at stafford bunnings, then head out to the BP on waterworks road for fule, then up up and away we go.

We can chuck a stop in at the coffee club if you want however, I have no isssues with that, except they might be a bit pricey and I dont like mcshittles.

But its not a bad surgestion at all, its on the way, so im happy to go with it. Also open to other ideas too.

Link to comment
https://www.sau.com.au/forums/topic/153441-closed/page/3/#findComment-2866745
Share on other sites
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      S1 rb25/s14 starting problem

      By Duncan · Posted

      Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Waders360
      M35 Brake caliper replacement

      By Waders360 · Posted

      Sorry. Front brake calipers
    • MBS206
      S1 rb25/s14 starting problem

      By MBS206 · Posted

      Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...