Jump to content
SAU Community

Recommended Posts

hey guys,

i have an r32 gts-t and my car seems 2 jerk in 2nd and 3rd when i floor it from 4000rpm onwards.

it feels like the car wants 2 go but sumthing is holding it back. Something must be causing it struggle.

This doesnt happen all the time but does happen

Any help would be appreciated thanx guysss

:ninja::):laugh:

Link to comment
https://www.sau.com.au/forums/topic/154372-car-jerks-at-times-plz-help/
Share on other sites

Too vague, we'd need more info than that, one thing I'm 90% sure of is that its' either fuel, electrical, or mechanically related though......lol.

lol... well when it happens the car doesnt flow smoothly sorta like somethings cutting out therefore it jerks so it could be electrical.

a mate of mine seems to think that it could have something to do with my engine coils, could that be right?

thanx

Nah, you can buy them in the FS section here. Then you just swap it for one on the motor, and keep swapping it until you find the faulty one.

Takes like 2 minutes to swap a coil once the valley cover is off.

At what revs does it jerk?

Nah, you can buy them in the FS section here. Then you just swap it for one on the motor, and keep swapping it until you find the faulty one.

Takes like 2 minutes to swap a coil once the valley cover is off.

At what revs does it jerk?

hmm sounds good might chek it out thanx

it starts to jerk between 3500 and 5000 after that its usualy finee

If it was a coil and above 3500rpm, I've reckon it would keep missing right through the rev range once it started. Secondary winding [if nissan coils have them, not sure] collapse would be at or over 3500.

Maybe the problem is elsewhere.

the car is pretty much standard apart from a cat back exhaust, pod a BOV.

standard computer

might change sparkies................

just out of curiosity how much would a bosch fuel pump be and will it change anything performance wise????

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...