Jump to content
SAU Community

Recommended Posts

  • Replies 282
  • Created
  • Last Reply

Top Posters In This Topic

"You see Billy it's like this, you either smoke or you get smoked. And you got smoked"

"You can put a cat in an oven, but that don't make it a biscuit."

"A black man would rather miss than look bad."

Tora Tora Tora

wrong

everyone is just posing up quotes haha.

isnt it supposed to be....quote...correct answer...your turn to quote

ive posted up enough correct answers

I've seen it but can't put my finger on it...

hahah tis easy

its #3 in the tri-series :P im sure u know wat i mean

I like to picture Jesus in a tuxedo T-Shirt, coz it says like, I wanna be formal, but i'm here to party too. I like to party, so i like my jesus to party

Talladega Nights: The Legend of Ricky Bobby

booyeah

"I was born ready motherf**ker"

Edited by 342Four
I thought it might have been beverly hills cop...wasn't sure though...still can't put my finger on who says it to who and when...been a while since I watched it

axel says the first line then inspector todd says the next one

just like how in number 2 axel says:

"i just thought that if there was a problem....."

then todd interrupts by saying:

"dont think axel it makes my dick itch"

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Is this where I say "Hey man my airbox cost me horsepower in my Naturally Aspirated Engine"? (I know you need them for legality in NSW)
    • 1.5mm alloy folded up, it will need a tweek, as the angled bend only got to around 45° as that was the max that the break press would get with the other bends, and I needed a fair bit more, but and the alloy is easy to bend too my will by hand once I trim the lower section out I'll Dremel out and form the angle and mounting point on the lower section when time permits  As for the lid, I'm looking at going a "cap", instead of a flat lid to hide the fixtures a bit
    • I got sick of thinking about batteries so just kept buying chargers. I've got a ctek (racecar), a "noco" thing from supercheap (tow car with 2 batteries), and an old "SupaCharge" branded lead acid thing (farm ute/mower) and will need 1 more when the Silvia gets a battery again (if the 86 stays).  I always make sure the charger itself is in free space/away from car etc, just to be sure.   
    • The "long nose" diffs in your type of car, that have the speed sensor on the snout, are a pain because the casing is different from all the other short nose diffs. This means that the pinion shaft inside them is longer, which can make it harder to do certain types of diff swaps. But, if all you are going to do it swap the diff centre, and keep the gears (that's the crownwheel and pinion gears) then you won't have any problems.
×
×
  • Create New...