Jump to content
SAU Community

Recommended Posts

Hi guys,

I've got these available...giving QLD a chance to get in before I get cleaned out of the last sets.

Suit R33 and R32 ie 5 x T10 LED globes @ $20 + postage a set

3 sets of Blue

3 Sets of Red

1 set of White

parkerdash.jpg

Also have parker lights available here:

http://www.skylinesaustralia.com/forums/in...howtopic=157082

thanks,

Dan

Link to comment
https://www.sau.com.au/forums/topic/157228-dash-leds/
Share on other sites

I should have another lot mid March, I'll keep everyone posted with a new 'For Sale' Thread when I've got them.

The high-power interior lights will be here then as well, it's a full set of 2 x map-lights and a dome light. All rated at >35Lm (friggin' bright) ultra white. You can't buy these anywhere as I've had them custom made. Everything else on the market is embarassingly weak in comparison.

These are $27 + delivery per set

They will also be available at $10 a bulb if you don't require the whole lot.

Link to comment
https://www.sau.com.au/forums/topic/157228-dash-leds/#findComment-2921770
Share on other sites

OK I've only got the parkers available now.

Massive bulb influx on March 27th though :P You can pre-pay if you wish, then you're guaranteed a set.....I know they're after about 200 sets on NS as they got shafted on a group buy by some tool.

Link to comment
https://www.sau.com.au/forums/topic/157228-dash-leds/#findComment-2938670
Share on other sites

Massive bulb influx on March 27th though :happy: You can pre-pay if you wish, then you're guaranteed a set.....I know they're after about 200 sets on NS as they got shafted on a group buy by some tool.

omg i just read that thread and initially thought i had missed out on a gb ... lucky for me i did miss it ...

Anywho im after a blue dash led set for my sexy blue 200 (s15) i have no idea what size bulbs i need. I also have a pillar mounted boost gauge, so probably an extra blue T5 would be good. When your ready to sell em let me know and i can transfer some $

Link to comment
https://www.sau.com.au/forums/topic/157228-dash-leds/#findComment-2957244
Share on other sites

  • 3 weeks later...


  • Similar Content

  • Latest Posts

    • My thought is if you were just moving it forward and the upstream geometry remained the same, then no difference at all. But because the current one has the filter direct into the AFM inlet, you effectively have the best chance of a completely symmetric air flow profile upstream, and in, the AFM, whilst the aftermarket inlet thingo has a (small, to be sure) bend between the filter and the AFM. That would bias the flow to the outside of the bend (downstream of the bend) which might well reduce the size of the signal seen by the AFM, for the same total flow rate. Having said that: If you're proposing to make your inlet look like a hybrid of your existing one and the aftermarket one, such that there is no bend where the filter is clamped on... then I say it will be just fine. If there is going to be such a bend, then, if you can align the insertion of the AFM blade such that it is at right angles to the plane of the bend, then there is a better than even chance that the centreline velocity where the blade is will remain more or less the same, and the velocity will just be a little faster to the outside of that, and just a little slower to the inside. **This is not professional investment advice and you should consult a suitably qualified ouija board, tea leaves or the intestines of a goat for more accurate prognostication.
    • Hi Tao, Thanks for your reply.  It's been a while and I managed to get the valve stem seals replaced with the head on the car.  Unfortunately this didn't solve my issue, the car still smokes a lot after idling (to be honest during idle you can see a bit of blue smoke from the exhaust), same after deceleration. I will try disconnecting the valve cover breathers, do I leave the PCV valve in? By engine oil drain pipe, do you mean the turbo oil drain?
    • What about if you just give it direct 12v and earth?
    • Hi guys . Can someone help me  I bought an Android screen for my Nissan fuga but it won't turn on   
    • My guesstimate, with no real numbers to back it up, is it won't effect it greatly at all.its not a huge change in position, and I can't see the air flow changing from in turbulence that much based on distance, and what's in front of it. Johnny and Brad may have some more numbers to share from experience though.
×
×
  • Create New...