Jump to content
SAU Community

Recommended Posts

Here is my beautifully customized Hyundai.

It barely resembles a Hyundai now, you could say it now barely resembles a car, it's more like something God would drive! Yes it's that good.

Every-thing has been upgraded:

Custom top quality vinyl (pink) throughout.

Supercheap race bucket seats

Geedy gear shift

Mobo steering wheel

Apoxi boost gauge

Monster tacho (42cm)

Titanium race exhaust with admantium muffler

Aluminum fiber piston kit with raised compression

Dooftronic MP3, JCV , DVD player with 60 Inch Plasma in boot

Nankang Semi rubber race tyres with carbon fibre valve caps

Trusk coilover suspension

There is to much to mention:

Yes, it goes like a Greek whore on Crack and sounds like farts from Thor's mighty ass.

It's been dyno'd at 47HP AFW.

Yes front wheel drive! Superior handling and drive.

You want to be seen, you want the respect? You Bitches gota earn it!

BAM $31,000 ono

Text 0419796484.

post-26350-1171975165.jpg

Link to comment
https://www.sau.com.au/forums/topic/157306-the-ultimate-gth/
Share on other sites

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...