Jump to content
SAU Community

Expected Power Output?

R34NRG

By R34NRG,
in Engines & Forced Induction

 Share

Recommended Posts

R34NRG Grand Master

R34NRG

Posted
Posted (edited)

Cars heading into the shop tm for a dyno tune with the following mods

Boost Controller

Power FC

Full TUrbo Back Exhaust with screamer pipe

FMIC

Pod

how much power should i be expecting and at what boost levels.

im also not to sure on how much boost i can run before seriously dropping my turbos life

Edited by Beer Baron
Link to comment
https://www.sau.com.au/forums/topic/158013-expected-power-output/
Share on other sites
G_Force Community Regular

G_Force

Posted
Posted
200kw at 12psi....damn ...will i encounter any problems if i run it at 12psi constently?

Yeah round 200rwkw or just short.

12psi is safe, stock 34 turbo runs out of efficiency after that anyway, risk of shattering that ceramic wheel exponentially increases after that.

12psi constantly?? Unless ur planning on having ur foot flat to the floor at all times.

R34NRG Grand Master

R34NRG

Posted
  • Author
Posted (edited)

lol no i ment just set it to 12psi whne i do have my foot flat

do u guys recommend anywhere i can tune my car. ive read the shops that SAU recommend but does anyone really recommend anyone there?

i was thinkin about RE customs in VIC

Edited by anDru
R31Nismoid Grand Master

R31Nismoid

Posted
Posted

Please use the search function of this forum.

Results sticky have 8 pages worth aswell, and requires no search to even be performed.

Im sure you can find at least 3 or 4 results on there, plus the countless others posted.

As for workshops, they are all listed/covered in the Vic section as you are very much aware of.

So please go have a read of that section and its related sticky threads.

cheers

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • blind_elk
      Wheel refurb?

      By blind_elk · Posted

      The powder coating came in at $250 EACH. The TRX rims got a coat of clearcoat on the outside only.    
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Bit wet, but YUMMY
    • GTSBoy
      Pops when backing off throttle, rough-ish sound through rev range.

      By GTSBoy · Posted

      Keeping in mind that I am currently getting flat 10 L/100km on my RB25DET, which means >>500km/tank. I would test this car for vacuum leaks, check codes and AFM signal with NissDataScan as D says, check plugs, do a compression check while they are out.
    • Duncan
      Pops when backing off throttle, rough-ish sound through rev range.

      By Duncan · Posted

      It is hard to be specific half way across the world...but it *seems* like it might have a minor issue. Is the idle stable and does it rev smoothly? I would not expect any pops out of what I am assuming is a standard ECU, standard tune, standard exhaust. You can use Nissan Data Scan to find out exactly what is happening when it runs, the cable/software is reasonably affordable if you are not planning on changing the ECU (which hopefully you are not with an NA skyline) BTW your mileage may not be that far off, these are heavy old tech cars, and being NA might mean you use a heavy foot to keep up with traffic....
    • AdiR34
      Pops when backing off throttle, rough-ish sound through rev range.

      By AdiR34 · Posted

      Hey guys! Y'all are the masters so figured I'd check in on a few items here. - My engine sounds ever-so-slightly more raspy than the other NA RB25s I've listened to. It's barely noticeable but definitely a slightly different sound. - When I back off the throttle at high RPM, I will sometimes get a pop out of the exhaust, assuming this can be diagnosed as misfire. Some history on the car: - Had an exhaust leak in auction sheet but was claimed to be fixed by seller (bought from USA importer).  - Car's coil packs and sparks were replaced when it was sold to me, but unsure on what the gap is and whether the coil packs are correct.  - A prior mechanic had misdiagnosed a pilot or throwout bearing sound as LSPI/detonation. Had played with timing a bit, pops/raspy sound of engine just got worse. Got timing reset. - Had failed emissions a few times. First time went in as is, failed. Second time, replaced cat, still failed, running rich as hell. Third time replaced o2 sensor, passed. Car still smells gassy though. - Timing belt and valve cover gasket also replaced.  - Gas mileage is... low. about 350-400K per tank.  Any idea if I'm having any serious issues here or does this all sound like normal old NA RB stuff and I'm fine to drive it with the pops/slightly raspy engine? If it'll help, I can get drop a video of the sound of the engine.
×
×
  • Create New...