Jump to content
SAU Community

Recommended Posts

Hi guys,

selling a 1993 Nissan Skyline GTST-4. Its a 5 spd manual turbo with GTR bodykit 18 inch wheels with good tyres pod filter catcback exhaust , sunroof, keyless entry alarm turbo timer. Car was serviced regulary and recently spent 1K at Centreline to get the whole front end bushes etc replaced and aligned

Cars is leaking water from the headgasket therefore compression locked due to water being in the cylinder but other than that drove well.

Its on 175,000 kms of that 75,000 kms of it was done by me. I have purchased anothe car and have no need for it.

Car is registered until 26/03/07...

Im located in melb for any1 wishing to view the car... PM me or call me on 0408 57 86 27

post-22220-1172912744.jpg

post-22220-1172912763.jpg

post-22220-1172912783.jpg

post-22220-1172912801.jpg

post-22220-1172912818.jpg

Edited by nuR.spec
Link to comment
https://www.sau.com.au/forums/topic/158950-r32-gtst-4-price-dropped/
Share on other sites

  • 3 weeks later...

^^

gts4 - 4wd

gtst - rwd

gts4's have a torque gauge in the dash were as gtst's have a boost read.

umm yeah, gts4's have the same drivetrain as gtr's. drop in an rb26 and you got yourself a gtr :thumbsup:

so obviously that would make em a tad heavier.

think thats about it

Edited by R-SPEC
  • 3 weeks later...
  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Absolutely could be. I collected data logs from when the O2 sensor was still out and also after I had replaced it so will try to compare them. Pretty confident that the affect is lowered with the new sensor, will check logs at the same RPMs/conditions. 
    • Hey guys Long time lurker, I daily a nm35 stagea 250t rs four and I've had it for almost 2 years (very reliable 👌). Issues or just looking for information ill always find myself here having a read, so thought id join.  3inch stainless intake, pod filter, AM performance turbo dump pipe, 3inch hotdog, 3 and half inch stainless to 3 and half inch AM performance blast pipes. Bc racing coilovers. 18inch rims Hdi intercooler and trans cooler soon.  Here's my car
    • thanks for the advice on the box... i was thinking the 6 speed was better for cruising on the highway but on closer inspection and comparison the Rb 5 speed box was not too different...  So the choice is going to be the RB25 box... if I can save up and find one at the right price  
    • Thanks Matt, yes that's what i am aiming for. Just going to apply the right voltage and grounds to the dash connector. Hence my search for these pins... any chance you know if these pins are in the same spot as the ones on the S15 Dash connector? as mentioned above on page 8?
    • Yes, unfortunately that's the one. Signal was noisy to begin with; after driving once and looking back at the logs I saw pressure constantly swinging between 0-200psi, or staying at 0 randomly for a few seconds. There's a lot of good sensors that share the same look and feel, so don't presume they're all bad. I bought mine for 20$ off Amazon and I should have read the reviews prior, as it's clear they're junk.  I purchased a lowdollerr motorsports sensor. 
×
×
  • Create New...