Jump to content
SAU Community

Recommended Posts

Hey guys I am chasing some parts for my R32, I hope some of you guys can help me out.

Car: 92 R32 GTS-T Coupe

Parts Needed:

Drivers side air vent (the small circle on located on top of the dash. Mark maybe able to help me out.)

UPDATED 22nd August

Edited by Triptych
come on guys some of you must have some spare parts laying around.

This guy in W.A has a stack of stuff that maybe some interest

http://www.skylinesaustralia.com/forums/in...howtopic=148692

I know it's W.A but heres the link anyways

Ryan I just want to thank you for all your help you have given me so far. Everybody I have come in contact with so far in this communty has been really nice and helpful. Thank you all and hopefully it won't be too long before I get this car looking as good inside as it is outside.

I will do spook. I am starting to think of trying my luck with Nissan or maybe Clark Rubber. Might also be time to start ringing the local Import Wreckers to.

  • 2 weeks later...

well i am pretty sure the pump is fine, I am thinking it is the sensor that is the problem with my fuel guage not reading right so I am going to try swap over the sensor to see if that fixes it. PM me a price your looking at for the sensor. I will be checking out my fuel system tomorrow when I do my coolant and oil change.

Also my holidays from work start on tuesday so that should give me some time to give this car a good look over and start fixing things. One really annoying thing is my Door open light stays on. I have tried replacing the sender in the doors (both sides) and it still does it so I am guess a wire has been disconnected somewhere along the line.

Edited by Triptych
  • 4 months later...


  • Similar Content

  • Latest Posts

    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
×
×
  • Create New...