Jump to content
SAU Community

Constant Dead After Stereo Installation, Clock Not Working. Fuse?

Haxorz

By Haxorz,
in Car Audio & Electrical

 Share

Recommended Posts

Haxorz Rising Star

Haxorz

Posted
Posted (edited)

Hi guys,

After a stereo installation on my R33, my constant wire seems to be dead. It had also caused my clock to stop working. At first the clock was just resetting back to 1:00 but now it doesn't show at all.

Any idea if this is a fuse?

Can anyone recommend a decent auto electrician or car stereo installation place in inner Melbourne / Prahran area to fix this issue and install the stereo?

Regards,

David.

Edited by McCracken
DRD-00F Grand Master

DRD-00F

Posted
Posted

sounds like you grounded that constant wire and shorted a fuse... its pretty easy to fix, open up the fuse box and look for one that has broken...

it also sounds like you stole the constant wire from the clock... you should make your own from the battery...

  • 2 weeks later...
Mark84 Contributor

Mark84

Posted
Posted
tee hee, your welcome :(

i have asimilar problem except i couldn't get my stereo to work ... the clock is not working and i have checked the fuses and none are blown and clock still not working any ideas guys i want my clock and stereo lol

DRD-00F Grand Master

DRD-00F

Posted
Posted (edited)

did you check your power wires? im a little drunk, so im not sure about anything, but check your power wires... run some wire straight from the battery to the 12V line on your headunit... if that works, then your power wires are Effed in the A somehow... run new ones...

you have to try both 12V and Acc, the headunit wont turn on without the Acc one attached... so if you chuck a 12V constant on that, and it works, it means your Acc is f**ked somewhere along the line...

either wire or fuse... run a new wire from the fuse to the head unit, if that works, that side of the power works... if that doesnt work, the 12V line to the Acc fuse is f**ked...

trial and error is fun :(

be careful :rolleyes:

also, more info helps sometimes :)

also, i hope that made sense, cause im not proof reading it...

Edited by DRD-00F
DRD-00F Grand Master

DRD-00F

Posted
Posted

its possible... but i think everything in that cluster uses the same fuse/power lines... your better off getting a long cable and going straight from the battery...

but try it, ive never had that exact problem, so give it a go...

DRD-00F Grand Master

DRD-00F

Posted
Posted (edited)

man im getting jipped :rofl: my fuses are in the engine bay...

but yeah, theres 2 lots of fuses... when we say 'check fuses' we mean both lots... one is above your right shin when you drive, the other is either in your engine bay on the left (from drivers seat) or in the boot?

Edited by DRD-00F

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hi 🙋‍♂️. Just bought my Unicorn but the interior need some minor work so it would match my expectations ;). I noticed it is hard to get used oem floor mats in good condition so i started to dig if there's any chance to buy set of new ones. I found two websites - nengun and amayama and it looks like one can still buy factory new floor mats in Japan, but thers a small issue. Some mats (i assume genuine, oem ones) are marked as G4900 and these are "discontinued". The ones you can buy are marked as G4911 but i have no idea if these are also oem, made by other producer or some lower quality replacements that looks entirely different. Can anyone help? 😃  P.s. there is also some strange indication - 0V005, 0V015 and 0V505. Any idea what does it mean? Would appreciate any help with this 🙏
    • Marek
      Hi everyone.

      By Marek · Posted

      Hi, Marek here 🙋‍♂️. I finally fulfilled my longtime dream - recently bought Stagea and now waiting for it to arrive in Poland. There's only few of these in my country, and one of the owners  recommended mi this forum as a source of all the info i'd need since now i own one  so here i am.  
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Version 1 aluminium airbox is.......not acceptable No pics as I "didn't like the look.....alot" Even after all my "CAD", and measurements, the leg near the fusebox just didn't sit right as it ended up about 10mm long and made the angle of the dangle look wrong, the height was a little short as well, meh, I wasn't that confident that Version 1 was going to be an instant winner I might give Version 2 another go, there's plenty of aluminium at work, but, after having in on and off a few times, and laying in the old OEM airbox without the new pod filter and MAF, there may be an option to modify the OEM air box and still use the Autoexe front cover and filter.... maybe This >  Needs to fit in here, but using the panel, and not the pod, the MAF will need to fit in the airbox though> I'm thinking as the old OEM box and Autoexe cover that is sitting in the shed is just sitting around doing nothing, and they are relatively abundant and cheap to replace if I mess it up and need another, it may well fit with some modifications to how the Autoexe brackets mounts to the rad support, and some dremiling to move it get in there, should give me some more room for activities, as I don't want to move the MAF and affect the tune Sealing the hole it requires to stick it in the air box is simple, a tight fit and some pinch weld will seal it up tight  I am calling this a later problem though
    • Dose Pipe Sutututu
      Ethanol Content Sensor - Always at 11%?

      By Dose Pipe Sutututu · Posted

      and it ends up being already priced in as though you're just on 91RON without any ethanol. Car will lose a bit of economy as the short and long term fuel trims bring down the AFR back to stoich or whatever it is for cruise/idle for the engine.  
    • soviet_merlin
      Ethanol Content Sensor - Always at 11%?

      By soviet_merlin · Posted

      Oh, you are right. But, in Australia E10 is based on 91RON fuel and ends up being 94RON. Hence it being the cheaper option for economy cars. The more performance oriented cars go for the 98RON fuel that has no ethanol mixed in. The only step up we have left then at some petrol stations is E85.
×
×
  • Create New...