Jump to content
SAU Community

Recommended Posts

Hey EOI at this stage.

87 HR31 Coupe

Engine:

R32 RB20DET silvertop, comes installed and running

Justjap FMIC, with aluminium cooler piping

Older style HKS turbo (been told similar to a VLT but with bigger exhaust and intake wheels)

3'' dump pipe and full Jasma exhaust

Air con taken out of engine bay (all the interior air con is still there)

Driveline:

R32 5-speed, just been reco'd about 5000ks ago

Exedy h/duty clutch (suitable for about 220rwkws)

Nismo h/duty pivot for clutch

Nismo braided clutch line

Suspension:

Brand new KYB all around

Front R31 House stabilaser bushes

Rear R31 House sub frame bushes (Hardened)

Front Cusco strut tower bar (brand new)

Brand new Cusco brake master stopper

Brakes:

Front HR31 100mm brakes with Endless pads

Front DBA slotted rotors (brand new just fitted)

Reco'd front and rear calipers

Interior:

All original interior

GTS-R leather shift boot

Greddy boost guage

Gizzmo shift light

Original skyline floor mats

JVC head unit

6 '' pioneer splits in front and rear (rears dont have tweeters or crossovers)

2 x 10'' subbies in box with amp

Front drivers seat has all the lumbar and the other one support

Exterior:

Needs a respray (been in garage for to long)

Brand new front bar with intercooler vent (hole not cut for vent)

15'' alloys with brand new Sumotomo tyres (225/50/15's all around)

Has had rear spoiler removed

Brand new front windscreen fitted about 2 months ago

Spare parts:

2x RB20DET nics motors

Centre console from a HR31 coupe

Original front bar that came with it

All the engine air con (compressor needs a reco)

Front struts (with 88.9mm spacing or whatever it is)

Rear Pedders comfort rider shockers

Rear GTS-X spoiler

Intercooler (Repco brand) that came with R32 Motor

Spare pressure plate and clutch plate from 32 motor

RB20DET nics head with bent valves

Brand new genuine Nissan water pump for R32

Brand new Gates racing timing belt for R32

RB20DET silver top loom and ecu

2x RB20 nics looms and 1x ecu

And anything else i cant remember.

Im in victoria and looking above the 6500-7000$ marks

Ill get pics up asap

Link to comment
https://www.sau.com.au/forums/topic/164544-hr31-coupe-unfinished-project-vic/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Did you pay with a credit card? I'd be putting a charge back through then finding a new sparky to sort it out. 
    • If you mean the alarm immobiliser; theyre internal to the alarm itself which makes that difficult; I couldnt even see where he put it; its not in the same place as last time; but with all black wiring it might be very challenging to trace  I had someone turn the key for me as I know it only primes for a couple of seconds As my post above; I am getting no voltage to the pump at all; but I am testing continuity of the power line (SB) from the pump plug to the relay fine. As well as the negative from the pump plug to a 12V constant.    Yeah; he blammed the no start on a bad battery; said I needed to get a new battery and it'll start. Turns out the battery drained because the tail lights had been on for half the day during the install (the rubber cushion on the brake switch gave out while he was testing it as I have a picture of the car from that morning with the tail lights off..i've replaced that). The battery was turning over the engine just fine for a long time; but got low since lights were draining it so it was too low to test a start after he finished. I bought a new one on his advice...$250 wasted. My original battery charged up just fine and is healthy.    It was running perfectly fine when I messed up the old alarm (programmed out the remotes). He couldnt start it after removing the old alarm; my assumption is that when he unhooked it; he didnt bridge the circuit back when trying to start it. Its always been perfectly fine. The ECU swap and pump were 2 years ago. It's never missed a beat in that time. 
    • This is a big issue for me without the diff. I just have zero drive from the passenger side when drivers side has no traction. Bec's parents place has a crazy steep driveway with odd camber and I have never been able to get up. My bro-in-law's 130i with an (unknown brand) LSD gets up fine as does their dad's Hiace. My car stays at the bottom. We have other odd camber roads around here as we're elevated a bit and if it's raining I can get totally stuck around some hairpins. 
    • Yeah, I am super excited for this.
    • Was the car running before he touched the car?
×
×
  • Create New...