Jump to content
SAU Community

Recommended Posts

for sale

r33 a set of kei office coil overs with tops no leaks looking for 750 down to 650

r33 a 3 inch dump / front pipe good nic no rust or dents 100

r33 gtr n1 nostrils bought from just jap for 140 never used for 130 down to 100

top end of r32 rb20 head inlet manifold polished coil pack cover not sure what its worth so make a offer

to4 garret non ball bearing .6 front and 1.15 rear not chinese brand new cost me 1100 will sell for 850

stock exhaust manifold heat sheild 20 bucks

r33 rb25 t 6 coils and loom 100 bucks

r 33 turbo rubber intake good nic no cracks 50 bucks

pics of some stuff

http://s135.photobucket.com/albums/q147/si...a%20S13/r%2033/

located in sydney welcome to come check m out

post up or pm if u r interested will post at buyers expense

selling as i have to much stuff and too much debt

Edited by KLR33
  • 4 weeks later...

howdy, intereseted in coil packs and loom (it is for a r33 gtst?),can u tell me the condition of coil packs and why u are selling ? where are u located? cheers Damo

Edited by madaz R33
howdy, intereseted in coil packs and loom (it is for a r33 gtst?),can u tell me the condition of coil packs and why u are selling ? where are u located? cheers Damo

condition of coil packs is good no cracks or burns

i m selling because i sold my r 33 so i dont need the spares

located 5 mins from liverpool

pm me if u wana come past n check m out

cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Not sure what you mean by electronic speedo drive.  Speedo reads fine up to 180 yes.
    • For anyone interested, this is my old graph from 2021, but I've plotted the previous setup curve onto it with a black pen. old setup was: pon cams, oem itbs and plenum, HPI manifold, hks 2835 pro S .87ar rear, Turbosmart actuator, 3" turbo back no res. or cat., greddy spec M fmic, nismo 740cc inj, walbro in tank 460, splitfires, 4" intake pipe, Apexi pod, e85, eboost2, power Fc. I love that the new setup has much larger turbo spec with the HTA3076 1.01ar Ts rear, and literally everything is bigger, but far higher quality and result is it's FAR more responsive in paper.
    • This makes a lot of sense! I just had that realisation a few minutes ago and wrote it above haha. This is a good new discovery. "Sanding the side of the hill" perfect way to put it.   😂 😂 
    • This is probably what's happened to me. I'll put filler again on my repairs and use the long block and let you know how I go. Fingers crossed it's my last batch of filler lol. I can see that happening where my block dipped at certain points because it didn't cover all the high spots at the same time if that makes sense. I'm just trying to visualise the fact that with the large sanding block I will be sanding far away from the central dent area and whether that will cause issues or whether that's going to fether out my repairs better.
×
×
  • Create New...