Jump to content
SAU Community

Recommended Posts

i have to 2x 10's at the moment, entry level eclipse SVC 200rms per, reveiving 250rms per, in a total of 1.9cuft and they sound fantastic, consistant 137dbs! upgradign to 2 Soundstream 10's(750rms) they will be fiberglass in the corners of the boot to retain the centre boot space.

fiberglass enclosures are your friend!

Please don't quote dbs unless it was done proffesionally...

i have run (not all at the same time) 1 x 10", 1 x 12", 2 x 10", 2 x 12", and to be honest there isn't a lot in it. a single 12 will sound better than a single 10" but once you go double they sound similar. i ran 2 10's in a festiva and if you cranked it up you could make the engine stall. it would make you feel sick after about 1 song

Im assuming standard battery and tiny wires with horrible ground points in a plastic car? :(

for the record i have run (not all at the same time):

1x10 (1 setup)

1x12 (3 dif setups)

2x12 (5 dif setups)

3x12 (1 setup)

1x15 (2 dif setups)

2x15 (1 setup)

I have a CDT 12" sub in the boot tucked into the drivers side corner, very small im pretty sure my ICE guy said it was 1.2 cubic foot enclosure. Not 100% sure, but i believe this is about the smallest enclosure you can put this sub into. Awesome sound quality without too much big boomy bass, im pretty sure it would be a lot louder with a bigger enclosure though. BTW it runs of a single DD 1000W Amp, enough kick for 2 of these subs.

Just look for a sub that does what you want, check the specs you would be surprised the kind of enclosures that some subs require.

http://cdtaudio.com/testreport_2.htm a review of the sub on the CDT website

post-11434-1187249723_thumb.jpg

cheers

Evil

from my experience it depends what speakers you have, in order to match for the bass, my 10" alpine x sound great at low volume but drops off very quickly as its increased trying to keep up with the 4 amped 6" speakers

im currently running 2 12" boston G2's, they are exelent take up a bit of room but i swap back to my 10" for trips out of town for the weekend

Good point about the speakers. I have CDT 6.5 Splits up front and Alpine Type R Coaxials in the back running off a Lanzar Amp. I find as long as you have the ability to adjust the volume on your sub/s then turning the volume down is not so much an issue. I am frequently reaching for the sub control as i listen to a range of different music styles. Im lucky my headunit can control the bass, as well as having the volume control for my sub up front. I imagine sound deading your boot would do a lot to keep the bass "in cabin", (warning off topic) which is something i will doing soon, as my next upgrade is a set of Hertz Mille MLK2 up front, move my CDTs to the parcel shelf and run the 4 speakers off a 4 Channel Amp, looking at the Audison Vrx 4.300. Also wouldnt a 12in sub be able to still move more air at a lower volume?

cheers

Evil

Basically the Short answer is this...........

Go for what ever sounds best to you. No-one can tell YOU what sounds good to YOU.

If you like the Punch from 2 10in Subs then go for that, Or if you think that 12's sound sweeter then that's what you want.

Personally I have always prefered the Low Rumble from a 15in, but that may have to go by the wayside when I finally get my 34 (Space may not allow it).

The general rule of thumb is the smaller the speaker, the quicker it can react to signals.

The Choice also depends on the type of music you will listen to.

Hopefully this may have given you something to mull over.

If all else fails, Seek help from a Professional.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
    • Any going to watch World Time Attack at SMSP this year?
    • Appreciate the correction on the "ground", that will make a huge difference to looking at this. That makes complete sense about AF70/AF71 which is what I had come down to being the issue, one of these. I'll have another look in the ignition wiring when I get a chance next week. I'll also make up a jumper wire for running that AF73 test.  ECU is fine, relay itself is fine, pump harness is fine and the pump itself is fine. I am going to upgrade the Walbro 255 anyway with a DW300 I have since I need to replace the fuel sender and I'm going to upgrade the FPR with my chasebays kit ready for new plenum/injectors/dbw, but I'll get this working first. That's why this is so frustrating. 
×
×
  • Create New...