Jump to content
SAU Community

Recommended Posts

Putting my GTR back up for sale, this is not some 89 model japbuilt poor condition R32. Clean white R32 GTR – late 1993 model, good condition, interior perfect etc.

83'xxxKM's - engine built @ 79'xxx

Location: Toowoomba - QLD(just over an hour from Brisbane)

Email: [email protected]

Phone: 0424529457

Bit of a list I put together…

Handling:

Ohlins coilovers

Whiteline rear sway bar

Hicas lockbar

Nolethane bushes front & rear

Whiteline front swaybar

Aftermarket castor rods

Strut bar

Slotted DBA rotors front & rear.

Braided front & rear brake lines

Japanese rims with Federal 595SS rubber

Engine:

Oil Control:

• Tomei restrictor

• External oil return from rear of cylinder head to sump

• Heads match ported

• Oil gallieries 20% larger

• Baffle in cam covers

• Tomei sump baffle

Block machined & chemically cleaned

Shotpeaned rods

Tomei brake cylinder stopper

Titanium split dump pipes

Trust exhaust

R33 GTR crank

N1 oil pump

ACL bearings

Tomei oversized pistons

Tomei gaskets

Tomei Pon cams & gears

Tomei timing belt

New harmonic ballancer

N1 water pump

All new belts

HKS2530 turbo’s

HKS IC pipeing kit

100mm thick Trust front mount intercooler

Additional PWR external oil cooler + GREX oil filter relocation kit. Earls braided lines & fittings.

Modified 75mm PWR alloy radiator

Custom recycling catch-can

Bosh 044 fuel pump

600cc Injectors

Aftermarket clutch

Blitz Sus pod air filters.

Clear cam cover

Bonnet pins

Interior & electronics:

Aftermarket mafless ECU

Turbotimer

HKS Electronic boost controller

Omori gauges(Oil temp & pressure, water temp)

HKS boost gauge

Tacho with shiftlight.

Penlight for low oil press warning

Short shifter

Driver & passenger genuine Recaro SR3 reclinable bucket seats including genuine recaro rails.

RPM race gear driver & passenger harness’s

Other stuff:

Genuine Momo steering wheel

Razo shift knob

Nismo fuel cap

Razo pedals

New Sony headunit

No expense spared, oil(Motul 300v Competition) & filters changed every 3000KM’s. Motul RBF600 brake fluid.

Car will not disappoint, pleasure to drive have ensured all mods done right so no problems with defects etc.

$29'900 Negotiable

post-10131-1181195960_thumb.jpg

post-10131-1181195970_thumb.jpg

post-10131-1181195982_thumb.jpg

post-10131-1181195990_thumb.jpg

Edited by Minko
Link to comment
https://www.sau.com.au/forums/topic/171819-built-r32-gtr/
Share on other sites

  • 3 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...