Jump to content
SAU Community

Recommended Posts

  • Replies 50
  • Created
  • Last Reply

Top Posters In This Topic

Updated price list.

Whole car - $700ono without wheels

Same Rims different tyre than pic - $350 needs tyres

Bootlid - $100

Spoiler - $80

Rear bar - $150

Tail lights - $70 each

Window regulator - $80 each

Steering wheel no airbag type - $80

Dash cluster 128kms - $80

RB25det Airbox - SOLD

Passenger side gaurd - SOLD

Interior - $200 complete will seperate parts

Passenger pwr window switch - $50

Driver side pwr switch - $60

Rb25de - $400ono

Dash cluster surround - SOLD

Parcel tray - $50

Passenger side door - $100 without reg or door trim

Ignition barrel, key and matching door locks - $100

Climate control unit - $40

Floor carpet - SOLD

Middle console - $30

Rear window - $80

AFM - $80

All prices are negiotiable.

PM for any other parts as car is complete.

Edited by R33_GTS-t

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • It says 300ZX, does that make it an Aus delivered car? Funny how back in the day I just couldn't care less about Z32's and these days I am just in love with them. Back when Nissan was into pushing the envelope. 🤣
    • Hi guys, just after some guidance with an R34 sunroof that has stopped working correctly. It still opens and closes perfectly fine, but it no longer tilts/vents up or down. As a result, the rear of the glass now sags a bit as it drops down slightly in order to retract into the roof, but now it can't pop upwards into a flush position. I’ve probed the pins on the back of the switch connector with a multimeter and it seems like both switches (for open/close and tilt/vent) still work correctly. Any ideas on what it could be, or where I should even start in terms of diagnosing? I'm sure someone's had this issue before but I haven't been able to find anything online relating to this specific issue, most of the issues are with the seals leaking or the motor failing entirely. Thanks in advance!
    • Do you have some data like fuel pressure? It's really hard to say if you're still fighting a fuel system issue at this point. Could be something weird like the FPCM dipping out.
    • Yeah in that case, pulling the dent out. Event a very slight dent can create a lot of work filler-wise and there is a strong chance the panel won't be the factory shape when you are done (as the dent will result in a new high point created somewhere, then everything is brought up to that new high point... but the panel shouldn't be that high if that makes sense).  So you've filled and primed the panel and it is flat, why would you go back and remove the primer and add more filler? 
×
×
  • Create New...