Jump to content
SAU Community

Recommended Posts

:/ R34 GTT MANUAL

This car is in excellent conditon and drives beautifully. It is basically in standard condition besides the few small mods listed below. As you can see in the new pics the sticker has since been removed and a few subtle changes made for a smoother look. I am selling due to raising funds for a property purchase and am after a quick sale.

<FONT size=5>BLACK

5 SPEED MANUAL

60,000

BLITZ EXHAUST

BLITZ POD FILTER

BLITZ TURBO TIMER

HID KIT

PIONEER HEAD UNIT

VOLT STABILIZER KIT

FACTURY UV TINT

ALARM

TYRES AROUND 85% TREAD

I am asking $24,900 ono, i am open to all reasonable offers so feel free to give me a call anytime on SOLD SOLD SOLD

post-39951-1183624705_thumb.jpg

post-39951-1183624720_thumb.jpg

post-39951-1183624730_thumb.jpg

post-39951-1183624743_thumb.jpg

post-39951-1183874369_thumb.jpg

post-39951-1183874923_thumb.jpg

post-39951-1183875027_thumb.jpg

post-39951-1183875089_thumb.jpg

post-39951-1183875166_thumb.jpg

post-39951-1183875233_thumb.jpg

post-39951-1183875344_thumb.jpg

post-39951-1183875431_thumb.jpg

post-39951-1183875520_thumb.jpg

post-39951-1183875578_thumb.jpg

post-39951-1183875643_thumb.jpg

post-39951-1183875764_thumb.jpg

post-39951-1183875832_thumb.jpg

Edited by Magdalicious
  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

Ho do you come up with that? This is currently the cheapest Advertised in South Australia. The next cheapest advertised car in SA is $27,000 so how is $24,500 too much? Its a low km manual with no accident history and is at the cheaper end of the market so in my opinion its worth its money.

In case you have not read any of my posts i am open to offers as i have been from the start.

It's simple. A car is only worth what someone is willing to pay for it.

Bad time to sell a car thats all.

I payed over 35 g's for my r34 but that was about 3 years ago.

The market has been in free fall for at least a year or so.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...