Jump to content
SAU Community

Recommended Posts

Hello all,

Organising a meet and movie to see 2 Fast 2 Furious @ Dandy Drive ins on the 21st of June... Lets make this a big one! Tell one tell all.

Gonna follow the plan from the last drive ins cruise so meet at Dandenong Stock Yards @ 6pm, meet & chat then onto the movie @ 7:30 (starts at 8:30 - gates open 1 hour early).

I recommend that people bring food and drink because stuff is quite expensive there (unless Vickii brings us all food again :P).

I will speak to the cops before hand and promise good behaviour in exchange for no trouble. It was fine last time. And from what I have heard there was no trouble at Coburg on opening night.

Let us know if you're coming. Do people need directions again?

Coming so far (assuming cops don't bother us):

- MaXiMuS007 (with his car back)

- HotSky

- DJ_L3ThAL

- MzDeFecTeD

- 32_envy

Interested:

-RedLineGTR

-Al

(P.S. Not hijacking JET-33's gold class nite, but drive ins are cooler so come to both!)

its awesome

the 34 is fkn NUTZ!

even if u ring the cops, it doesnt matter, theyl just say theyl leave u alone and b there in unmarked cars/clothing...take down plates..and send out letters...

especially at dandy...its like a few kms from the illegal drags which they r currently goin double nuttz on and im tippin its a sat nite too..?

hmmmmmmmmmmmmmmmmmmmmmmm

  • 2 weeks later...

Hrmm so is any1 still coming?

The whole point of this for me was to celebrate getting my car back but as that has been delayed i'm not even in the mood to go any more *cry*

Guest
This topic is now closed to further replies.


  • Latest Posts

    • Thanks for that mate always a good help
    • It's not really a calibration issue, if the voltage is really at 2V. If the voltage is 2V, then that's what the TPS is putting out, and the Haltech is seeing that and 2V is about 40% open (you know, between 0.45v being closed and something close to 4.5V being fully open). So, that would suggest that the TPS is maladjusted, on crooked, something something something. Or a wire problem.
    • Hi guys my TPS voltage is reading over 2v at idle.  My Haltech ECU is reading around 40% throttle position at idle also which is really strange. Note the actual throttle position sensor is brand new…    anyone have any experience with this or know how to calibrate it on Haltech ? 
    • The OEM disk will not work on any AEM ECU, you need to use the one they made. You shouldn't have to flip the CAS or whatever you were describing, if you set the ignition sync offset correctly it can't backfire. Make sure you're using a spark plug lead on coil 1 instead of the timing loop to avoid weird issues with the timing light. Double check that your timing settings are actually correct, like is the 24 tooth configured correct or should it actually be 12 teeth for 1 crank revolution? I also found this: 305817248-AEM-Undocumented-Settings-v1-2.pdf    
×
×
  • Create New...