Jump to content
SAU Community

Recommended Posts

Just think of it this way...

now they have talked to you and know your name, you may be less interested in doing something silly

you you might have done if you didnt think they would know your name and address.

Maybe they did you or your 30 mates a favour....

Ah pipe down they were doing thier job, your 15 and the world is against you. I wouldnt worry.

When your old enough to own a house or have possessions of any worth, you'd care that this was being done aswell.

And yes, they are allowed to ask you questions. You dont have to answer, but you must give you name and address i believe.

Well actually you dont even have to give your name and address unless your driving.

Legally the police are allowed to search you and take down details under the following circumstances.

1) They have reason to believe you are carrying an illicit substance or concealed weapon or have been involved in a crime

2) You agree to it

3) They have a warrant.

The following by themselves are not legitimate reasons:

1) "Increasing crime in the area"

2) The time is 3am and your walking on the street.

3) You are driving a defective vehicle

4) You are not of anglo ethnic origin

5) You are wearing clothes including a hoodie that are cheap, not washed, and "typical" of criminals

6) You looked at them funny

but mayb theres something your not telling us

Edited by Taso84
Well actually you dont even have to give your name and address unless your driving.

Yes they do under circumstance.

Under circumstance Police have the right to ask you to identify yourself.

By giving your name and address, or alternatively showing ID.

Well actually you dont even have to give your name and address unless your driving.

Crimes Act 1958

Section

456AA. Requirement to give name and address

(1) A member of the police force may request a

person to state his or her name and address if the

member believes on reasonable grounds that the

person—

(a) has committed or is about to commit an

offence, whether indictable or summary; or

(b) may be able to assist in the investigation of

an indictable offence which has been

committed or is suspected of having been

committed.

(2) A member of the police force who makes a

request under sub-section (1) must inform the

person of the grounds for his or her belief in

sufficient detail to allow the person to understand

the nature of the offence or suspected offence.

Like i said in my earlier post, they would have taken ur details to help them in any future investigations. So in this case it comes under Sub-section 1 (b) and by informing you about the increased crime in the area the officer has satisfied Sub-section 2.

;)

ok so basically according to GTR STEALTH's post, they are allowed to take your details.

They would've taken mine anyway because i didn't have any id (and still dont).

Taso84 is this research or what you THINK is right, i think i know which one, and also stop assuming that there isn't something that i'm not telling you. If you're trying to imply that i am a young criminal i'm pretty sure that i wouldn't be posting on here where the police could find me through my ip address etc.

ok so basically according to GTR STEALTH's post, they are allowed to take your details.

They would've taken mine anyway because i didn't have any id (and still dont).

Taso84 is this research or what you THINK is right, i think i know which one, and also stop assuming that there isn't something that i'm not telling you. If you're trying to imply that i am a young criminal i'm pretty sure that i wouldn't be posting on here where the police could find me through my ip address etc.

What GTR stealth said is true, what i was trying to iterate was that they cant ask u for no reason, like general crime, there has to be a specific offence that u could assist with the investigation.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Stock ECU (or more accurately stock tune) absolutely refuses to go over 10psi and behaves like you have seen. The Nistune is the same if it is the stock tune. If the Nistune chip has been tuned, the resulting tune could be literally anything for any combination of parts. The Nistune just makes the stock ECU Tunable.
    • So stock ECU does not like anything above 10 psi?  That Nistune one is just for "try" if it will be any different, I know it need to be tune for that. I know but YOU may know about these problem but i/we dont. They few little Skylines here let alone people who know anything about tham so that is why iam asking here  
    • So now we have a radiator with no attachments whatsoever. It lifts up with a particularly tight spot between the drivers side air box mount and the lower radiator outlet, but if you've got this far you will sort that too. This is the lower mounts with the rad out so you can see where the rubber bushes go, it is a straight shot upwards Done! Assembly is the reverse of disassembly, with blood less likely to be shed.
    • Right, onto the second last trick. The Air Con condenser is mounted to the front of the radiator and stays in the car when the radiator is removed. There are 2x 10mm headed self tappers holding the top of the condenser to the radiator, remove those The bottom of the condenser is attached to the radiator with clips. You need to lift the condenser out of those clips and clear (up, then forward). f**ked if  could work out how to do that last bit with the front bumper on. I hope you can, and you share the trick.  Bumper removal probably deserves its own thread one day once I've recovered the will to live, but basically you need to remove the wheels, front inner guard liners (clips and 10mm headed bolts), the self tapper between the guard and the bumper at the rearmost point of the bumper (same as an R32 that bit), any remaining clips at the top/front of the grill, an absolute bastard design with a plate that holds the top of the bumper above the headlight each side (only 1 bolt which is tricky to get to, but the plate catches 2 places on the bumper and must be removed....carefully!) and push clips between the bumper and guard under the headlight. If you've done all that you will be faced with wiring for the fog lights on both sides and in ADM Q50 RS at least, 4 nasty tight plugs on the driver's side for the ADAS stuff. So, the clips at the bottom look like this on drivers side (looking from the front) And on the passenger side (also from the front), you can see this one is already out Clearance on both of these are super tight; the condenser needs to move up but the upper rad support mount prevents that, and the radiator can't move down far because it is (rubber) mounted. Once you achieve the impossible and drop the condenser off those mounts so it does not stop the rad moving, you are good to go
    • OK, next the shroud needs to come off and there are a couple of tricks. Firstly, there is a loom from near the passenger side headlight to the fans, coolant temp sensor etc and there is no plug to undo.  In my case I was OK to leave the shroud on top of the engine so I just undid the passenger side fan plug and about 10 of the clips which gave enough free wire to put it aside. The fan plugs were super tight, the trick I used was a small falt screwdriver to push down on the release tab, then a larger flat screwdriver to lever the plug out of the fan unit....be careful with how much force you apply! If you need to remove the shroud altogether for some reason you will have to deal with all the plugs (tight) and clips (brittle)....good luck. I removed all of the clips and replaced them with cable ties that I will just cut next time. Also, in the Red Sport / 400R at least, the intake heat exchanger reservoir hose is bolted to the shroud in 2 places with 10mm headed bolts; so remove them (the hose stays in the car; no need to undo it at the t fittings down at the radiator lower mount. Once you've dealt with the HX hose and the wiring loom, there are 3x 10mm headed self tappers holding the top of the shroud to the radiator; remove those.   The shroud then lifts out of the bottom mounts where it sits on the radiator, up and onto the engine out of the way. Simples
×
×
  • Create New...