Jump to content
SAU Community

Recommended Posts

Anyone want a new SAU jacket?

We need 20 buyers to get this going and we have 9 confirmed buyers so far.

Pics, prices and sizing info - click here

PM Nick for payment details and for any enquiries - click here

:laugh:

Link to comment
https://www.sau.com.au/forums/topic/177963-skylines-australia-jackets/
Share on other sites

  • 2 weeks later...

Just spotted the payment details in the link lol. In that case, when do you want payment. Are you taking payments now, or only when you have 20 people in the group buy?

Winter is over now!!

I may still get one though....

depends on what a damn water pump and timing belt is gunna cost me and how little I'll have left after it :cheers:

Just spotted the payment details in the link lol. In that case, when do you want payment. Are you taking payments now, or only when you have 20 people in the group buy?

Hey Ryan,

we need payments before the order is made, that way we know we won't be making orders for people who will back out at the last minute, leaving us with stock which is hard to sell...

So what is the groupbuy price for the jackets?

Any pictures of the BLUE jacket?

ditto

and

ditto

I have been watching for a response to these two questions and didn't see one *nag nag nag* LOL there are prices on the link, but they are unclear to me (unless I've missed something somewhere) as to the normal price vs GB price vs member price.

Also, you said that they were a "stylish nipple warmer" but the jackets didn't look long enough *innocent look* :D

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...