Jump to content
SAU Community

Recommended Posts

a shit load of degreaser and a high pressure hose.

try some stuff called 'bug and tar remover' if that doesnt work which you'll find at repco or supercheap. its top stuff.

but still use a high pressure hose, or a paint brush if you're keen on getting inside the fins.

I use an alloy wheel cleaner thats acid based and it never touched the paint, I've also used a descaling acid before with great results, spray it on with a pump spray bottle, then pressure wash it clean, comes up like new :laugh:

Worth testing what ever you try on paint work first just in case though.

Edited by DriftyR33

Just spray some degreaser on it, after its on there for a while wash it off with some warm soapy water and a high pressure hose, then just rinse it off with some hot water.

Most car wash's these days have warm water on there "high pressure soap rinse" option, so just use that!

The warm water does make a difference! :D

Dont get to close with the high pressure hose, they have been known to damage the fins on the cooler due to the pressure.

Thanks,

Abu

Edited by abu

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
    • OK, so again it has been a bit of a break but it was around researching what had been done since I didn't have access to Neil's records and not everything is obvious without pulling stuff apart. Happily the guy who assembled the engine had kept reasonable records, so we now know the final spec is: Bottom end: Standard block and crank Ross 86.5mm forgies, 9:1 compression Spool forged rods Standard main bolts Oil pump Spool billet gears in standard housing Aeroflow extended and baffled sump Head Freshly rebuilt standard head with new 80lb valve springs Mild porting/port match Head oil feed restrictor VCT disabled Tighe 805C reground cams (255 duration, 8.93 lift)  Adjustable cam gears on inlet/exhaust Standard head bolts, gasket not confirmed but assumed MLS External 555cc Nismo injectors Z32 AFM Bosch 023 Intank fuel pump Garret 2871 (factory housings and manifold) Hypertune FFP plenum with standard throttle   Time to book in a trip to Unigroup
×
×
  • Create New...