Jump to content
SAU Community

Recommended Posts

Hey,

Ive noticed recently that when i reach 100km/h i get a huge vibration feeling throughout the car.

Cant even see through the rear view mirror as its vibrating.

Vibration can be felt through seat, gearstick etc basically the whole car.

This started to happen after a new clutch install...

Is there any chance this could be caused from the installation?

Thanks

Link to comment
https://www.sau.com.au/forums/topic/188319-vibration-at-100kmh/
Share on other sites

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

was the flywheel machined properly? wat sort of clutch was installed? was the tailshaft done up properly? is the crossmember rubber mount done up properly? the 2 little bolts in the middle of the crossmember get forgotten about alot

flywheel was machined by workshop

exedy heavy duty clutch with 1050kg pressure plate

Not sure about all the other questions as workshop/mechanic did the swap.

Will be going tomorrow to have a talk.

Just wanted some info from SAU before i head over there :P

Took it to a wheel/tyre specialist, they took car for a test drive and said it wasnt wheel balance/alignment related.

Taking car back to mechanic on Friday to see if he can fix the problem, mentioned to him that it could be tailshaft and he said it could be a possibility.

thanks turboedsloth

Yeh, i suddenly had a haggard vibration through the tailshaft of my old gts-t once at a pretty high speed, arrived at home and had a look under the car, 1 of the bolts from the bracket that bolts the tailshaft to the undercarriage had fallen out and it was hanging on a 20 degree angle, luckily no damage, evil thing

Just got back from mechanic which double checked the tailshaft.

Everything is tight and put back the correct way (tailshaft was marked upon removal etc)

Ill book in for a 4wheel balance regardless of what the test driver said, that way i will be 1000000% sure it isnt a balance problem hehe

  • 1 month later...

I am having the same problem with my GTR. Judging by the fact that you have a GTS-T, helps me rule out anything to do with the 4WD system.

I can tell you it isn't a wheel balance because I just had new tyres put on a week ago accompanied by a full electronic wheel balance. Everything showed 100%.

I have been told it could be the diff and so far, I am believing it. If you find out before I do what the problem is, could you please let us know?

I'm in Melbourne too and wouldn't mind meeting up to know for sure if you're problem is the exact same as mine. Sounds like it though.

Fulvio.

PM sent, mechanic also mentioned that if a wheel balance doesnt fix the issue, then it could be the diff.

Getting camber/castor/steering rack/pineapple bushes changed as we speak along with remove/replace of a leaking power steering rack.

I will let you know if i still have a vibration problem afterwards

hrmm

well all my suspension bushes have been replaced and a 4wheel balance & wheel alignment were done yesterday.

Vibration is still there at 100km/h

Went back to the suspension place to double check everything, and he mentioned that if the vibration is felt through the back seat, floor etc then it is a driveline vibration.

Also mentioned that it is the tailshaft as in the r32 its in 2 parts or something and happened after clutch install.

hey guys! i just had a similar prob, i had a gearbox replaced and the car had vibration

at over 80kph, it ended being the centre bearing was shit and the tailshaft needed to be 15mm longer. but the damage also went to the yoke seal on the gearbox.

best thing to do is take it to a driveline specialist. not including the price of the box,

that monkey mechanic who didn't check his work has cost me $1200.

could have bought a rb25det box after all,, :D

excuse my stupidity but where is the centre bearing you speak of?

i have the same exact problem aswell, approx 105km/h and it shakes, only gets worse and you go faster too

have a feeling its the diff or gearbox as it makes a grinding noise between 2-2.5k on each gear aswell AND also can hear a bearing spinning noise (input shaft bearing?) when the clutch is not pressed and its sitting in neutral

tek 01, the centre bearing sits roughly half was between the gear box and the diff... best way to check if it's buggered or not is to through yourself under the car...may need to be jacked up at the rear and push and pull on you tail shaft, if it moves around and clunks it's stuffed... if it stays relativly 'center' it's not you centre bearing... we have a distributer in makcay called hardy n spice.... thats where i got mine from...they seem to know there stuff

have a feeling its the diff or gearbox as it makes a grinding noise between 2-2.5k on each gear aswell AND also can hear a bearing spinning noise (input shaft bearing?) when the clutch is not pressed and its sitting in neutral

sounds alot like your thrust bearing...is it absolutly every gear that it grinds at 2-2.5 k?........ how many K's on the car?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • You'lll likely have to make do with R33 GTR for engine/tranny stuff, and Stagea for the body. I don't know that there's even been an actual diagram seen in the wild.
    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
×
×
  • Create New...