Jump to content
SAU Community

Recommended Posts

Ok I'm sorry to change the topic back to cars and all but i need help :dry: . R32 hicas lights keeps coming on, turn the car of and it goes away? something i need to worry about??? and could it have something to do with the shuttering i get sometimes while turning corners?????????????????

Got a killer price on a pair of GT2860r -5's today $1,950 USD shipped. cant get any better than that :dry:

Thats a very good price Chad although I reckon I saw someone on here that could get them for $1150 AU each ($2300 AU pair)

Yours are probably still a tad cheaper even with the conversion rate but they need to come from the US

slouch, a member on the forums here can get them for $2150AU delivered, from the US and A

Thats who im going through, but i was told via email today by the supplier $1950 USD which = about $2070 AUD and thats to my door.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...