Jump to content
SAU Community

The Sa Wasteland

Cubes

By Cubes,
in South Australia

 Share

Recommended Posts

  • Replies 36k
  • Created
  • Last Reply

Top Posters In This Topic

  • Damo_R34

    2820

  • scandyflick

    2266

  • Madaz

    1919

  • craig R33

    1717

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Ryanrb25
Ryanrb25

i went for a hills run last night in the 31 with the roads very slippery.....was much fun. Had to bed in the bottom end bearings so yea..took it for a strap.

DSTROY
DSTROY

Hey Ryan, do you know how to fit a set of drop spindles to the front of a hilux???

Madaz
Madaz

Dam straight Damo would rather do SAU them heroin gts4 are 4.1 because they share the same parts from the gtr i think r32 gtst is 4.3 because of the lack of torque from the rb20

Posted Images

craig R33 Grand Master

craig R33

Posted
Posted (edited)

^^ i would to.

but its good that they didnt go to far with things.

shows, if we do the right thing (behave) the police will start to realise that we are not the ''typical'' ''hoon'' import drivers

meh, im just a whore, never mind me

Edited by craig R33
rad100 Grand Master

rad100

Posted
Posted

its true craig and as kellie said i think..

we are an australian wide clud cruising all the time! we keep it sensible and if anyone messes up they will be reported...

and hence y kellie gives her name out as the organiser over the cruise! to show them we are dead set about keeping it safe and under control!

wow i think this is one of my few quality posts! hahaha

heslo Grand Master

heslo

Posted
Posted

Know how you feel there Craig (sick as a dog part!) Good to hear you had a great cruise everyone, glad I didn't make it now, if I didn't get defected last weekend I sure as shit would have tonight :bunny:

Night all :P

Matty 31 Grand Master

Matty 31

Posted
Posted
Yeah, i was down arndale way. There was a holdup of some sort at the chemist down arndale and were millions of cop cars. Got pulled over by Hanson rd

by 2 old dudes in a police Toyota Landcruiser. Got done for spacers on the rear. Not happy about it since all i was doing was driving but yeah ..... Anyone

have a stock R32 steering wheel lying around??

Hanson Road is one of those areas thats generally swarming with cops anyway (and the areas around it). Our training centre is on Grand Junction Road (shares the same facility as the MFS training centre)....and when i used to drive the 31 to trade school id CONSTANTLY get followed (even in its more stocker form that it was over the years. Would usually get pulled over and asked why i was so far from home LOL

if ya have any trouble finding parts let me know, ive got some random stuff laying around that may help ya

Nene260RS Experienced

Nene260RS

Posted
Posted
yeh steve 4 more road traffic coppers came.. spoke to dan and jenkies and kel and searched cars!

was interesting!!

copper says "whos family car" hahaha

I'm so glad they didnt wanna check out the family car!! LOL

Cubes Grand Master

Cubes

Posted
  • Author
Posted
Pulled this yesterday, not bad for my lack of mods, running about 9psi i think.

Sounds about right. Little more boost will pick up 20-30rwkw but its the mid range that is worth while. Accelerates you to that peak power considerably quicker.

Bugger injectors and tune the sucker on E85 for 240rwkw on the std turbo. :D

Nothing wrong with E85. I'll be grabbing myself some larger injectors and retuning.

Damo_R34 Grand Master

Damo_R34

Posted
Posted

Haha yeah i have plenty of plans Cubes :D The dyno i had it on is made for commercial vehicle tuning, and apparently readouts are always a little bit less then everywhere else. Should be getting my power fc soon, so ill have the AFR tuned a bit better. Might look at injectors too.

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      S1 rb25/s14 starting problem

      By Duncan · Posted

      Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Waders360
      M35 Brake caliper replacement

      By Waders360 · Posted

      Sorry. Front brake calipers
    • MBS206
      S1 rb25/s14 starting problem

      By MBS206 · Posted

      Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...