Jump to content
SAU Community

Recommended Posts

Ok Help with the upgrades?

I've got rb20dett

480 injectors

33 turbo

3" exhaust straight thru

3" highflo intake

bleeder

fmic

spiltfire's

What upgrades can i do next "well best bang for my buck" they say??

HAHAHAHAHA ur mum said stop spendng money on ur car and get a house...

u sick of the power already??

get a highflow turbo! not much more u can do! there is a gcg hiflow r33 turbo in the fs section atm!! $1200..

Ok Help with the upgrades?

I've got rb20dett

480 injectors

33 turbo

3" exhaust straight thru

3" highflo intake

bleeder

fmic

spiltfire's

What upgrades can i do next "well best bang for my buck" they say??

A turbo that you can run 20pounds through to push up that mid range and get the car really accelerating quick. :banana:

yea i head that too!oil prices droped by alot over night so aparently unleaded will drop back down to 1.20 - 1.30!! premium will still be 1.40 tho lol but thats a hell of alot better then 1.78

WOO WOO

With my new daily using 5/8ths of fk all petty as it is, yay for cheap travelling :P Probably be cheaper to use the car than the bus :banana:

Ok Help with the upgrades?

I've got rb20dett

480 injectors

33 turbo

3" exhaust straight thru

3" highflo intake

bleeder

fmic

spiltfire's

What upgrades can i do next "well best bang for my buck" they say??

air freshner, windscreen wiper blade replacement and neons...lol

haha lies.. you wait until you have that 5k baby bonus sitting in your bank account. :P

lol you don't get that all in 1 go after January 09, you get it in installments

and anywayz it would only go on nappies and formula and whatever it needs.

the only shopping i like is dvd shopping :banana:

lol you don't get that all in 1 go after January 09, you get it in installments

and anywayz it would only go on nappies and formula and whatever it needs.

the only shopping i like is dvd shopping :banana:

oh, stuff that,

*nevermind wendy, false alarm* ha ha :P

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So, this shouldn't be such a mission, but there were a few tricks so I thought I'd post up a DIY for it. This was on a Q50 Red Sport but I doubt any other V37 model is very different (maybe just less steps for the intake heat exchanger hoses) I pulled the radiator out to flush it because the car was running hot at the track, but obviously the same steps apply for changing a radiator for any reason including an upgrade. If you are removing the radiator, you of course need to drain and refill, so have 5+ litres of blue coolant ready. You don't need to drain the intake heat exchanger to remove the radiator but depending on your plans you may need a couple of litres for that as well. You will also need something to deal with the auto transmission lines, I used 2x 8mm rubber caps on the radiator side, and a short length of 8mm pipe on the car side.....unless you can block these lines quickly you will loose AT fluid and it may be enough to hurt the transmission if you don't refill it. Other than that....lets go... "First, jack up your car". Yes really, and put it safely on stands. If you are not confident doing that you need to give this job to a mechanic
    • If the forester is anything like our old 2007 GTB Liberty, I could near on run ling Long's and "rate them", as no matter what, it just hung to the road, even when abusing it in a hard launch in the wet, or throwing it at corners.
    • LOL, all of the CAI like Craig I just need to put a hole saw through my bumper Done and dusted, the car runs, which is nice, I'll take it for a spin when the weather clears up Just need to put the bumper back on for good
    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
×
×
  • Create New...