Jump to content
SAU Community

Recommended Posts

hey Chad if you're serious we should go and see him together.....might get a better price for a couple of sets.

yeah, im serious. i want some new pipes before the turbos go on, im still pretty keen for those Greddy ones, just depends on the cost difference.

well i just need ones to suit 32, i have 34 front pipes now, so i'll have to modify my exhaust back to 32 specs. which should give me more ground clearance i hope.

Also dropped off my 34 gtr rims today to get painted, think im gonna get them painted the same colour as my Drift Teks.

so, got bored at about midnight, so i decided id take advantage of the half not shit weather and go out and get some pics of my car. found a pretty good spot out in port adelaide, and i stole petes spot in reynella :O, pretty cool for a church, lol.

shame the camera was acting pretty freakin weird for the last couple hours :P

we should probably just rig the lotto.

takes care of that 'work' issue.

that being said, i could go out, get myself a gambling addiction, have myself self-barred from all gaming lounges in sa, then claim work cover cause of my temptation to gamble while im at work :O

... yeah, rigging the lotto is a better idea...

is it the whole kit globes and igniters, becuase HID globes are different to halogen globes :O

Lol Steve of course it is the whole kit. however, i did buy globes to suit an R34 from 666DAN, then realised i didnt have factory HID installed, then i bought a HID kit to suit R34 minus globes.

666DAN

Yeah....666Dan, his kits are tops... make sure u specify if u need the aircon leds in addition to cluster/gauges...

also, i got an entire set of red ones that I took out to put blues in if anyone wants em

-D

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...