Jump to content
SAU Community

Recommended Posts

yeah i got a warning for it LOLLLL O WAT EVERRRRRRRR this is a joke i was refering to mitch im sure he doesnt take it PERSONALLY do you? ahahahahahhaha but i guess i hurt someone else feelings ahahhah SNAP

you know kietz you are such a hero where you stand my friend........but that's only because I've never had the pleasure of meeting you.....trust me when I say that you would be a little more respectful otherwise

there were 3 guys in my targets tonight and only one of them turned out to be a real man via PM (Tom).......the other 2 continued to act like little school girls

However, this is Wasteland so feel free to continue to act like dicks but you'll feel pretty silly next time we're all out on an SAU event and we cross paths........might be somewhat embarrassing me thinks

and you just pm'd me 'Treat all members with respect and courtesy - We will ban any member(s) who make personal attacks, threats or mistreats any other member in anyway (discretion is up to the moderator at the time of the offence)' tskkk im going bed now for real now. had enough of this bs

SEEING AS GOOGLE WONT LET ME GET THE GROUP HUGZ PICTURE

i am posting in words

Pete , sorry if you mistook my humour to be personal . it wasnt intended to be .

now you can take this as a genuine sorry or you can take it at face value and not care about it .

your choice.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
×
×
  • Create New...