Jump to content
SAU Community

The Sa Wasteland

Cubes

By Cubes,
in South Australia

 Share

Recommended Posts

Krishy Grand Master

Krishy

Posted
Posted (edited)

yay golf talk lol

i have been playing a fair amount of golf pretty much every weekend.....getting my scores down which is good...best so far has been 32 on 9 holes par 3....anyone keen for a SAU golf day....groups of 4

Edited by Krishy
  • Replies 36k
  • Created
  • Last Reply

Top Posters In This Topic

  • Damo_R34

    2820

  • scandyflick

    2266

  • Madaz

    1919

  • craig R33

    1717

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Ryanrb25
Ryanrb25

i went for a hills run last night in the 31 with the roads very slippery.....was much fun. Had to bed in the bottom end bearings so yea..took it for a strap.

DSTROY
DSTROY

Hey Ryan, do you know how to fit a set of drop spindles to the front of a hilux???

Madaz
Madaz

Dam straight Damo would rather do SAU them heroin gts4 are 4.1 because they share the same parts from the gtr i think r32 gtst is 4.3 because of the lack of torque from the rb20

Posted Images

Damo_R34 Grand Master

Damo_R34

Posted
Posted
I normally go around on my own in about 1.5 hours. But depends how good golf we play. OK, let's say 3:30pm at my place, that way we can have a roadie, and be on the course just before 4pm. If it gets to 5:40pm we can give up and head back to my place.

So, SLED is in, Madaz is in. Any other takers?

Fark! I have the day off, but im heading to victor at 12 for end of season cricket trip.

Krishy, organise a golf day!

Damo_R34 Grand Master

Damo_R34

Posted
Posted
Par 3 isn't the best of fun though..... Need to go out on a real course where you can at least take the big dog out and try nail one down the middle...... :P

North Adelaide is good for that

TALBO Grand Master

TALBO

Posted
Posted
North Adelaide is good for that

Yeah it's not too bad.... there's the Patawalonga as well near the airport as well or for a nice easy 9 hole course there's Regency. Sandy Creek and Mt Barker are a couple of my favs though.....

rad100 Grand Master

rad100

Posted
Posted
yay golf talk lol

i have been playing a fair amount of golf pretty much every weekend.....getting my scores down which is good...best so far has been 32 on 9 holes par 3....anyone keen for a SAU golf day....groups of 4

KEEEEN AS BREW!!!

nugzy31 Proficient

nugzy31

Posted
Posted
I make a point to NEVER pull between stationary cars to turn - even if they leave you a gap to do so - it is just too risky if you can't see who you are pulling out in front of. Just because you can't see them, doesn't mean a cyclist or motorcyclist isn't there.

I made that mistake on the side street between kfc and hungry jacks at reynella....everyone had stopped and left a gap..so i went through...some F@&$wit in a camry comes flying up in the turning lane and scared crap out of me so i booted it...luckily i was still n/a , only problem i was open wheel so i just wheelspan....4 cars back was a cop car which rapidly did a u turn and pulled me over to do me for excessive noise....they didnt care that the camry nearly hit me and i took evasive action..imo, they just saw a skyline with stockies

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • djr81
      R32 update from 1990's spec.

      By djr81 · Posted

      So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • djr81
      RB26DETT Sketchy boost mod?

      By djr81 · Posted

      Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...