Jump to content
SAU Community

Recommended Posts

i want that 32, just something bout it, ugly, but f**k, ugly is good for meaningless thrashing! (just like other things in life)

That thing was heaps fun to drive. Drifted pretty well for a basic set up, kinda wish I didn't sell it but it was a bit rough to use as a daily.

seems i might be moving to the dirty motherf**kin south, friend of mine is buying a house, offered me a room for $100/week...

sweet

south isnt that bad - what suburb?

also, man that chick in your avatar makes me crack a phat

seems i might be moving to the dirty motherf**kin south, friend of mine is buying a house, offered me a room for $100/week...

don't even think about coming down this neck of the woods bud.......you may wake up to find one of these sticking outta ya chest!!

PushDagger2.jpg

KnifeinChest.jpg

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...