Jump to content
SAU Community

Recommended Posts

Hey guys, im having trouble with the climate controll on my r34, even when its turned off and the fan isnt on, there seems to be alot of heat coming through around my feet mainly. Is there a common fault like the heater tap staying open just slightly????

Also if its set to 18' and no AC on it seems to have ambient temp air coming through but if its set on 19 degrees and up it seems to be on full and it defaults to the maximum fan speed. no matter what the ambient temp is the fan speed allways goes to full.

its driving me completely insane, and in summer god knows how hott in the car it will be.

is there any air speeed sensors or temp sensors that are knowen to fall out or fail?????

did i mention its running lpg injection which is great but i dont beleive it is causing the problems because the water in and out for the gas converter is b4 the heater tap............ too my knoledge that is

secondly.

i have a switch to the right of the steering wheel, it has a pic of a big fan and a little fan and you can toggle between the 2. it looks to be an oem, but has no wires going in to the back of it.

chris

Edited by urtwhistle

it could be one of the motors that run of the climate control has craped itself and is stuck in the hot position, my 33 did the same thing and i had to get a new motor to close the hot water tap. Just a though. Try and turn the car on listern for a noise when you change from hot to cold and see if it makes a strange sound or not and see if the heater tap in the engine bay changes position. Best of luck and remember to put up your response when you get it fixed.

cheers Andrew

Not sure if this will work for you...I had similar issues with mine last year..One day while doing an oil change I noticed just behind the front bar, there was a plug that was unattached, I found where it was supposed to go and plugged it back on...eversince, my climate control has been working fine. Go have a look and see if you can find the plug in the attached pic...if its unplugged, plug it back in...

post-6973-1193024854_thumb.jpg

hey, i'll have a look at that sensor 1st thing in the morning, i was playing with the car tonight.

if i set the climate control to manual all fan speeds work and zones. if i set it for 18 degress ambient air blows out. if i set it for 18.5 upwards red hot air flows out. i tryed listening for the motor or taps. were are they exactly??? are the taps in behind the dash or the engine bay????

chris

AFTER 6 WEEKS OF DRVING AROUND WITH THE HEATER ON I FINALY FOUND THE PROBLEM............. just above your left leg is a tiny little vent were the air con sucks a tiny amount of air though. well theres a small temp sensor sposed to be wired in behind it. the wires were hanging off mine. 2 sec job to reattach and the climate control worked perfect again.

yay for me lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Apologies for the long post, but needed somewhere to lay out the entire timeline of events and actions taken:   I've got an 89 GTR with a R34 RB in it. It's been running great all year, driven probably 500KM in the last month. It's not my daily driver, just a weekend fun car.    Build info: R34 RB26 - HKS 2.7 stroker kit, HKS adjustable cam gears, HKS turbo upgrades, Trust intercooler, R34 factory DENSO 440cc injectors, JUN chipped/tuned R32 ECU. All of this work was performed in Japan back in 2019.    Thursday 10/2/25 - It's a nice day and decided I'll drive it to work, I start it up in the garage and I notice it took a few extra cranks and sounded a bit funny. I figure maybe it was just because it was a pretty chilly morning. I pull it out into the driveway to warm up a bit before leaving. As I leave the driveway, it feels very off and sounds like a misfire. I pull it back in the garage to deal with after work and take the daily to work. I was able to diagnose it as a cylinder 5 misfire with the old spark plug test (unplugging each plug until a sound change with the engine running). I take off the whole ignition system, ignitor, plugs, spark. *Important note, it is still on the R32 ignition system with the separate ignitor system. I test each system with a multi-meter and nothing presents as a smoking gun. I put it all back together and it starts up no issue. I go ahead and order the PRP R35 ignition conversion kit. It should arrive today (10/13/25)   Friday 10/3/25 - Another nice day, car starts up great and drives great all day. Very pleased that everything seems to be OK   Sunday 10/5/25 - Decided I'll take it to play some golf, load up and drive to the course about 25 minutes away. Drives wonderful the whole way there, I pull in the parking lot and the engine completely comes to a stop. I do not recall if it sputtered at all, but just remember all of the sudden the engine was off. I roll it into a parking spot, try to crank it back on and nothing.  It'll crank and crank and not even try to start. End up getting it towed back to my house and push it up into the garage.    Items I have checked: Fuel in the tank Fuel Pump relay Fuel pump fuse  Spark Plugs & gap Coil packs Ignitor    I know the cylinders are getting fuel as the plugs smell like fuel after a start attempt. I tried spraying starter fluid into the manifold and cranking and not even a sputter.    I decided to do the live CAS test (removing the the CAS, ignition on and spinning the CAS stalk to see if the injectors pulse and spark is active). All of the injectors were pulsing and I have spark at the plug. The half-moon end of the CAS did seem very loose, I'm not sure how much play is supposed to be there, but it was more than I expected. There was no in/out play of the shaft, just the tip end that is pinned on had quite a bit of play.    CAS Play video   When I put the CAS back in, I stupidly did not re-time the engine. I know I need to do that tonight, however, I do not think it will start given it seemingly was not the issue. My plan is to do the PRP R35 coil kit and retime the engine at the same time.    I plan on ordering the Haltech Nexus Plug-in ECU once they are available again, but ideally would like to get this sorted before firing the parts cannon at it and potentially adding more variables.    Anything glaring that I am missing here, I'm a bit at a loss?          
    • Get it on a dyno. Get something logging Consult. Run it up and find out what is causing it.
    • Looking for a plenum for rb25 de+t neo  Not looking to push much power maybe 300kw at the wheels, is there much difference in flow for Freddy “Greddy style” compared to original Greddy or options like Proflow or Otaku garage?    I won’t be porting the de Neo head for now as I think it’ll be fine 280-300rwkw but appreciate the help and any experiences anyone has between them and any advice. Thanks  Looking at this plenum for now below 
    • engine wise almost no mods: stock ecu Greddy front mount intercooler Greddy forward facing intake w R33 TB stock fuel system, stock injectors, rail etc. Kakimoto racing hyper 3 inch exhaust system Apexi intake filter New NGK –R BCPRES (.8 gap) plugs  
    • Nice one @Pac - looks like a fair few 1600's there! 
×
×
  • Create New...